GGP ITALY HTJ 550 Manuel D'utilisation page 77

MAINTENANCE AND PRESERVATION
Cleaning of debris from the inner grooves must be
done regularly, as this could impede the bla des
from turning correctly.
Proceed with cleaning (Fig. 11):
– Loosen the nuts (1), remove the screws (2) and
the bar (3).
– Carefully remove any dust or debris from the
slots (4).
– Lubricate the internal surfaces of the blades.
– Remount the bar (3) with the screws (2), taking
care to reposition the spacers accurately (5) and
the washers (6) and (7) under the nuts (1).
– Fully tighten the nuts (1).
WARNING!
Always check that the
nuts (1) are tightened as far as possible be­
fore starting work.
SHARPENING THE BLADES
It is necessary to sharpen the blades when
the trimming performance decreases and the
branches tend to stick together.
WARNING!
Always replace and never
repair a blade which has blunt cutting edges
IMPORTANT
We recommend you take your
machine to your Retailer for sharpening as he has
the required tools and suitable experience.
In order to sharpen the blades, it is recommended
to use a fine grain file and proceed as follows (Fig.
12):
– Place the file (1) on the blade (2) at a 45° angle,
and proceed with upward strokes towards the
cutting edge.
– Make sure that you put pressure on the file only
when stroking upwards and raise it from the
blade when you move it back towards you.
– Only remove a smallest amount of material.
– Eliminate any burr with a grinding stone.
– Eliminate all grinding traces and lubricate the
blades before reassembling them.
EXTRAORDINARY INTERVENTIONS
All maintenance operations not foreseen in this
manual must be performed exclusively by your
Retailer.
All manuals and user guides at all-guides.com
All and any operations performed in unauthorised
centres or by unqualified persons will totally invali-
date the warranty.
PRESERVATION
After each working session, carefully clean the
machine from dust and debris, repair or replace
any faulty parts and lubricate the blades to prevent
them from rusting.
The machine must be preserved in a dry area,
protected from all weather conditions and with the
blade protection device correctly fitted.
PROLONGED IDLE PERIODS
used for a period of more than 2­3 months it is
recommended to follow some advice to avoid dif­
ficulty when you wish to use the machine and to
prevent permanent damage to the engine.
• Storage
Before storing the machine:
– Empty the fuel tank.
– Start the engine and allow it to tick over until it
– Allow the engine to cool down and remove the
– Pour a a teaspoon of (new) 2-stroke engine oil
– Pull the starter wire a couple of times to dis-
– Replace the spark plug with the piston in the
• Restarting work
When you wish to start using the machine again:
– Remove the spark plug.
– Pull the starter wire a couple of times to elimi-
– Check the spark plug as described in chapter
– Prepare the machine as indicated in the para-
IMPORTANT
If the machine will not be
comes to a halt, so that it uses all the fuel that is
left in the carburettor.
spark plug.
into the spark plug slot.
tribuite the oil in the cylinder.
dead end upper position (visibile from the spark
plug slot when the piston is at maximum stroke).
nate all excess oil.
"Checking the spark plug".
graph entitled "Preparing for work".
11
EN