Maintenance; Cleaning And Lubrication; Technical Data - KLIPPO S400B Manuel D'utilisation

WARNING! S400B - Switch off the engine and take off
the ignition cable before repairs or maintenance.
S400E - Inspection and/or maintenance should be
carried out with the motor switched off and the plug
disconnected.

Cleaning and lubrication

• Check that the cooling intake is free from leaves, grass
and dirt. Clean the cooling fi ns.
Clean the outside of the machine. Never fl ush water
•
directly on the engine.
• Lubricate all moving parts with engine oil.
Adjustment of cable tensioning
If the drive does not work as it should, the drive cable might
need adjusting.
Loosen the lock nut.
•
• Tension the cable by turning the tensioning screw.
• Tighten the lock nut.
Engine (S400B)
Air fi lter
• Loosen the fasteners on the sides of the air fi lter cowling
and remove the cowling.
• Change the fi lter.
• Refi t the air fi lter cover.
Engine oil
Check the engine's oil level (Image 7)
• Put the machine in a horizontal position.
Motor
Brand / Model
Cylinder displacement, cm
3
Power, kW
Fuel and lubrication system
Fuel tank capacity, litre
Oil tank capacity, litre
Engine oil
Weight
Weight without fuel, kg
Noise emissions (EC directive 2000/14/EC)
Sound power level, measured dB(A)
Sound power level, guaranteed dB(A)
Vibration levels
Vibration levels on the handles, m/s
Cutting equipment
Working width, mm
Working width, mm
Speed, rpm
Power transmission
All manuals and user guides at all-guides.com

MAINTENANCE

•
•
•
Changing the oil
Engine oil requires changing after the initial fi rst fi ve hours of
use, and then every 50 hours of normal use and 25 hours of
heavy use thereafter. Change the engine oil while the engine
is hot.
•
•
(Image 6)
•
•
•
Spark plug
•
Storage
•

TECHNICAL DATA

S400B
Briggs & Stratton 475 Series
148
-
1,9
0,6
10W-30
45
91
94
<2,5
2
400
0-15
3000
V-belt with clutch via a belt tensioner.
Unscrew the oil fi ller cap.
Check oil level and top up if necessary. The oil level should
be up to approx. 35 mm below the lower part of the pipe
opening.
Screw on the oil fi ller cap.
Empty the fuel tank by running the machine until the tank
is empty.
Remove the drain plug.
Tip the machine over and empty the oil into a suitable ves-
sel. CAUTION! The spark plugs should be facing upwards
when you tip the machine over.
Ask where you can dispose of surplus engine oil at your
local petrol station.
Put the plug back and fi ll with new oil.
(Image 8)
Clean the outside of the spark plug. Remove it and
check the electrode gap. Adjust the gap to 0,7-0,8 mm
or replace the spark plug. Change every 100th hour or
once every season. Always use the recommended spark
plug type! Use of the wrong spark plug can damage the
piston/cylinder.
When storing the machine for long periods the fuel tank
must be emptied. Contact your local petrol station to fi nd
out where to dispose of excess fuel.
S400E
Leroy Somer 230V + 50Hz
-
1,6
-
-
-
40
82
85
<2,5
400
0-15
3000
V-belt with clutch via a belt tensioner.
21