Remote Control (Optional); Cleaning Stainless Steel - Faber CYLN15SS600 Instructions D'installation

REMOTE CONTROL (OPTIONAL)

Installing the Battery
• The remote control is powered by a CR2032 type 3 V battery (not included).
• Remove the screw and install the battery.
• Check that the battery is installed with the " + " side up.
Caution:
• Do not place the remote con-
trol near heat sources.
• Do not discard the batteries
with normal waste, they must
be put into the specific con-
tainers.
• Tighten the battery cover
screw tight.

CLEANING STAINLESS STEEL

Cleaning Exterior surfaces:
Please note, abrasives and
scouring agents can scratch
range hood finishes and should
not be used to clean finished
surfaces.
Stainless Steel finish cleaning instructions:
Clean exterior surfaces with a commercially
available stainless steel cleaner.
33