How To Use; Control Board - ItsImagical babicare BBRobot Manuel D'utilisation

Blades
•
Rinse using plenty of water before removal.
• Carefully clean the surface of the blade with mild soap as to avoid cutting yourself. (Avoid
using other types of soap as the damages may be irreparable).
• Rinse using plenty of water.
We would advise against cleaning or rinsing the blades in a dishwasher due to the mois-
ture generated in its interior.

How to use

• The robot will only work if the power supply cord is plugged in, and if the parts are properly
inserted (cooking jug or sterilisation basket either fi tted to the base, fi tted by turning them cloc-
kwise).
1
2
How to fi t the jug How to fi t the lid
Important: Do not use without fi rst having poured the necessary quantity of food Important: Do not use without fi rst having poured the necessary quantity of food
and water. and water.
100
All manuals and user guides at all-guides.com
1 1
2
How to fi t the steriliser
• CONTROL BOARD: 1 switch (located on the rear) and 3 touch control buttons (located on the
front)
2
ON/OFF Switch
1 Located on the rear of the appliance: The 3 pictograms (steam, crush, va-
cuum packaging) will light up in green (indicating that the 3 functions are
ready to be used) If the cooking jug or sterilising basket are not correctly
fi tted, the steam and vacuum packaging pictograms will fl ash intermittently
in green until they are correctly fi tted.
Steam
2
When the Steam symbol is pressed, it will light up in blue, indicating that it is
ready to cook, heat, sterilise and/or thaw (according to the amount of water
poured). (See water dose table)
Steam symbol lit up in a fl ashing red light: The robot is hot (it is re
commended not to touch the appliance until the colour changes to
green (2 min.)
When fi nished you will hear 2 beeps, and automatically the 3 picto
grams will light up in green.
Blades
3
This symbol must be held down so that it may function.
Blades symbol in blue, BBRobot beating (after 10 sec of crushing, it will
automatically stop as a precaution so as not to burn the motor out).
After the fi rst cycle the pictograms will fl ash red, and after 10 seconds you
can press the blade symbol again.
Press down once again if you wish to keep beating (max. 2 consecutive
cycles).
After two cycles, the LED display will show a red light.
When fi nished automatically the 3 pictograms will light up in green.
Vacuum
4
Press the vacuum packaging symbol (symbol in blue for 3 sec.). During the
vacuum packaging, the symbol will light up in blue. When fi nished automati-
cally the 3 pictograms (touch control buttons) will light up in green.
If you press the vacuum packaging button again while the pump is in ope-
ration, the process will be cancelled automatically. The system will auto-
matically switch off for safety reasons if the nozzle is not connected to the
recipient or the pipe to the vacuum is not closed within an estimated waiting
time of 30 seconds.
EN
101