Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Testing the Remote Alarm
CAUTION
A test of the remote alarm should be performed prior to
initial use and after every change of battery. Test the alarm
periodically as per the facility policy.
Press
on the Remote Alarm.
The following will occur:
• The alarm LED illuminates and the alarm sounds.
• The LED corresponding to the set volume illuminates.
• The Disconnect LED blinks if the alarm is not connected
to the device and lights permanently if connected.
• The battery level LED corresponding to the battery level
illuminates. Yellow LED if battery life is low, or green LED
if battery life is good. (Replace the battery if the battery
life is low).
• If a second Remote Alarm is connected, the second
Remote Alarm will also sound.
Setting the volume
WARNING
When adjusting alarm volume, ensure that the alarm can be
heard above ambient noise levels.
A choice of three volume levels for the alarm can be selected.
The default setting is the highest level, intended for use in noisy
environments. A short press will show the current volume level.
To adjust the volume level:
Press and hold the
the blue volume LEDs will blink to indicate the volume level can
be changed.
Press
until you reach your desired volume level (low,
medium or high).
After 10 seconds of inactivity the blue volume LEDs will stop
blinking and the volume level will be saved.
Wall mounting the Remote Alarm
Refer to illustration E
Two types of screws can be used to affix the bracket to the wall.
A minimum of three screws (not included) is required.
WARNINGS
• Ensure the wall bracket is securely fixed in place.
• Ensure the wall bracket is located in an area that will not
be affected by moisture.
• When affixed to the wall bracket, ensure the Remote Alarm
cord does not pose a tripping or choking hazard.
1. Align the rear of the Remote Alarm with the guide-line on the
face plate of the wall bracket.
2. Holding the Remote Alarm against the bracket, turn the
Remote Alarm from
of the wall bracket) so that the side of the Remote Alarm sits
flush against the bracket and is held securely.
3. To remove from the wall bracket, turn the Remote Alarm from
to
unlock position and remove.
for one second. The alarm will beep and
to
position (as shown on the top
English
5
Publicité
Table des Matières
