Connecting To A Computer - Canon WG7000 Serie Démarrage

Installing the Machine

Connecting to a Computer

Before starting the configuration
EN
• There is risk of disclosing your personal
information if the machine is connected to an
unsecure network. Take precaution to secure
your network from unknown parties.
• The machine does not come with a router or
LAN cables. Please have one ready.
• The machine cannot be connected to a wired
and wireless network at the same time.
If you are using the Setup Guide, connection is
by DHCP where the IP address is automatically
assigned.
To use set an IP address other than by DHCP,
such as a fixed IP address, select <No> in the
wireless LAN connection screen and exit the
Setup Guide without connecting to the network.
Once the Home screen is displayed, refer to the
"Connecting to a Network with a Fixed IP
P.28
Address"
Choosing a connection method
• To connect via wireless LAN: P.10
• To connect via wired LAN: P.11
• To connect via USB: P.12
The above screen does not appear on WG7240.
Connect via wired LAN or USB.
Even in an environment without a wireless
LAN, you can use Access Point Mode to
connect directly to the machine wirelessly
from your mobile device (Direct
Connection). Exit the Setup Guide before
you initiate Direct Connection (WG7250Z/
WG7250F/WG7250).
Online Manual
10
and configure settings.
To connect via wireless LAN
• With a fixed IP address: Select <No>
and adjust margins. P.12
• By DHCP: Proceed with the following
steps.
1
Press <Yes> on the connection method
screen.
2
Check that your computer and wireless
router are properly connected.
3
Check the network settings on the
computer.
4
Take note of the network name (SSID) and
password (network key).
• Check the label on your router for this
information. Online Manual
• Setup can also be performed via WPS on
compatible routers. Online Manual