Canon WG7000 Serie Démarrage page 44

## are the REN without a decimal point (e.g., 03 is
a REN of 0.3).
A plug and jack used to connect this equipment
to the premises wiring and telephone network
must comply with the applicable FCC Part 68
rules and requirements adopted by the ACTA. A
compliant telephone cord and modular plug is
provided with this product. It is designed to be
connected to a compatible modular jack that is
also compliant. See installation instructions for
details.
Connection to party lines is subjected to state
tariffs. Contact the state public utility
commission, public service commission or
EN
corporation commission for information.
If your home has specially wired alarm
equipment connected to the telephone line,
ensure the installation of this equipment does
not disable your alarm equipment. If you have
questions about what will disable alarm
equipment, consult your telephone company or
a qualified installer.
In Case of Equipment Malfunction
Should any malfunction occur which cannot be
corrected by the procedures described in the
Online Manual, disconnect the equipment from
the telephone line cable, turn off the power and
disconnect the power cord. The telephone line
cable should not be reconnected or the main
power switch turned ON until the problem is
completely resolved. Users should contact their
local authorized Canon Facsimile Service Dealer
for the servicing of equipment.
Information regarding Authorized Service
Facility locations can be obtained by calling the
Canon Customer Center.
Rights of the Telephone Company
If this equipment causes harm to the telephone
network, the telephone company may
temporarily disconnect service. The telephone
company also retains the right to make changes
in facilities and services that may affect the
operation of this equipment. When such
changes are necessary, the telephone company
is required to give adequate prior notice to the
user. However, if advance notice is not possible,
the telephone company will notify the customer
as soon as possible. Also, the customer will be
advised of his/her right to file a compliant with
the FCC if he/she believes it is necessary.
Warning
The Telephone Consumer Protection Act of 1991
makes it unlawful for any person to use a
computer or other electronic device to send any
message via a telephone FAX machine unless
such message clearly contains in a margin at the
top or bottom of each transmitted page, or on
the first page of the transmission, the date and
time it is sent and an identification of the
business or other entity, or other individual
sending the message and the telephone
number of the sending machine or such
business, other entity, or individual.
In order to program this information into your
FAX machine, you should complete the
procedure to register your name, unit's
telephone number, time, and date. Refer to the
Online Manual.
For California, USA only
This product contains an internal battery for
backup purposes.
Included battery contains Perchlorate Material-
special handling may apply.
See http://www.dtsc.ca.gov/hazardouswaste/
perchlorate/ for details.
42
Users in Canada
Pre-Installation Requirements for Canon
Facsimile Equipment
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
When using your telephone equipment, basic
safety precautions should always be followed to
reduce the risk of fire, electric shock and injury to
persons, including the following:
1. Do not use this product near water, for
example, near a bath tub, wash bowl, kitchen
sink or laundry tub, in a wet basement or near
a swimming pool.
2. Avoid using this product during an electrical
storm. There may be a remote risk of electric
shock from lightning.
3. Do not use this product to report a gas leak in
the vicinity of the leak.
"CAUTION - To reduce the risk of fire, use only
No. 26 AWG or larger telecommunication line
cord."
IMPORTANTES MESURES DE SÉCURITÉ
CONSERVER CES INSTRUCTIONS
Certaines mesures de sécurité doivent être prises
pendant l'utilisation de matérial téléphonique
afin de réduire les risques d'incendie, de choc
électrique et de blessures.
En voice quelquesunes :
1. Ne pas utiliser l'appareil près de l'eau, p.ex.,
près d'une baignoire, d'un lavabo, d'un évier
de cuisine, d'un bac à laver, dans un sous-sol
humide ou près d'une piscine.
2. Éviter d'utiliser l'appareil pendant un orage
électrique. Ceci peut présenter un risque de
choc électrique causé par la foudre.
3. Ne pas utiliser l'appareil pour signaler une
fuite de gaz s'il est situé près de la fuite.
"ATTENTION - Pour réduire les risques d'incendie,
utiliser uniquement des conducteurs de
télécommunications 26 AWG au de section
supérleure."
Users in Canada
This device complies with Industry Canada
license-exempt RSS standard(s).
Operation is subject to the following two
conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference,
including interference that may cause undesired
operation of the device.
This equipment complies with IC radiation
exposure limits set forth for an uncontrolled
environment and meets RSS-102 of the IC radio
frequency (RF) Exposure rules. This equipment
should be installed and operated keeping the
radiator at least 20cm or more away from
person's body (excluding extremities:
hands, wrists, feet and ankles).
Pour les usagers résidant au Canada
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le
fonctionnement.
Cet équipement est conforme aux limites
d'exposition aux rayonnements énoncées pour
un environnement non contrôlé et respecte les
règles d'exposition aux fréquences
radioélectriques (RF) CNR-102 de l'IC. Cet
équipement doit être installé et utilisé en
gardant une distance de 20 cm ou plus entre le
dispositif rayonnant et le corps (à l'exception des
extrémités : mains, poignets, pieds et chevilles).
Pre-Installation Requirements
Notice
This product meets the applicable Innovation,
Science and Economic Development Canada
technical specifications.
The Ringer Equivalence Number is an indication
of the maximum number of devices allowed to
be connected to a telephone interface. The
termination on an interface may consist of any
combination of devices subject only to the
requirement that the sum of the RENs of all the
devices does not exceed five.
Conditions de pré-installation
Avis
Le présent produit est conforme aux
spécifications techniques applicables
d'Innovation, Sciences et Développement
économique Canada.
L'indice d'équivalence de la sonnerie (IES) sert à
indiquer le nombre maximal de terminaux qui
peuvent être raccordés à une interface
téléphonique. La terminaison d'une interface
peut consister en une combinaison quelconque
de dispositifs, à la seule condition que la somme
d'indices d'équivalence de la sonnerie de tous
les dispositifs n'excède pas 5.
About This Manual
Illustrations and Displays Used in This
Manual
Illustrations and displays used in this manual are
of WG7250F unless specified.
Cassette Feeding Unit
(optional) attached
Trademarks
• Windows is a trademark or registered
trademark of Microsoft Corporation in the U.S.
and/or other countries.
• Internet Explorer is a trademark or registered
trademark of Microsoft Corporation in the U.S.
and/or other countries.
• Apple, Bonjour, iPad, iPhone, iPod touch,
Safari, Mac, macOS and OS X are trademarks
of Apple Inc., registered in the U.S. and other
countries.
• IOS is a trademark or registered trademark of
Cisco in the U.S. and other countries and is
used under license.