Helpful Information; Energy Saving And Operation Hints - Panasonic CS-C9CKPG Manuel D'utilisation

HELPFUL INFORMATION

I Auto Operation Button
ECONOMY ECONOMY ECONOMY ECONOMY POWERFUL POWERFUL POWERFUL POWERFUL
• Raise the front panel and press
G Automatic Operation
• If the remote control fails to function or has been
misplaced, press the Auto Operation button to start
the Automatic operation.
• The Automatic Operation will be activated
immediately once the Auto Operation button is
pressed. However, temperature cannot be adjusted
when in this mode.
• The power indicator on the indoor unit will blink until
the operation mode is selected automatically.
• To cancel this operation, press once more.
G Remote Control Signal Receiving Sound
• To switch off the beep (Signal Receiving Sound),
press the Auto Operation button for 10 seconds
continuously or longer.
A "beep", "beep" sound will be heard after
ten seconds.
Note: A "beep" sound will be heard after five
seconds, however, please press continuously
until you heard the "beep", "beep" sound.
• Repeat the above steps if you want to switch on the
Signal Receiving Sound.
G (This is for Servicing purposes only)
Note: If you press this button continuously for 5 to 10
seconds, Test Run operation will be performed.
A "beep" sound will be heard after five seconds
indicating the Test Run has begun.
9
I Auto Restart Control
• If power is resumed after a power failure, the
operation will restart automatically after 3 - 4
minutes.
POWER POWER POWER POWER QUIET QUIET QUIET QUIET TIMER TIMER TIMER TIMER
• Operation will be restarted automatically under the
previous operation mode and airflow direction when
power is resumed as the operation is not stopped
by the remote control.
I Timer Setting
• When power failure occurs, the timer setting will be
cancelled. Once power is resumed, reset the timer.
I Thunder and Lightning
• This air conditioner is equipped with a built-in surge
protective device. However, in order to further
protect your air conditioner from being damaged by
unusually strong lightning activity, you may switch
off the circuit breaker.
ENERGY SAVING AND OPERATION
HINTS
I Setting the Temperature
• Approximately 10% of electricity can be saved.
• Set the temperature higher or lower than the
desired temperature.
Cooling Model
Cooling Operation : 1°C higher
Heat Pump Model
Cooling Operation : 1°C higher
Heating Operation : 2°C lower
I Air Filters and Air Purifying Filters
• Clean the air filters every 2 weeks and the Air
Purifying Filters every 6 months.
• Dirty filters may reduce cooling or heating
efficiency.
I Keep All Doors and Windows Closed
• Otherwise, cooling or heating performance will be
reduced and electricity cost is wasted.
I Outdoor Unit
• Do not block the air outlet vents. Doing so will lower
the cooling or heating performance.
I Timer
• To prevent the wastage of electricity, use Timer
when going out.
I Avoid Direct Sunlight
• Keep curtains or drapes closed to avoid direct
sunlight during cooling operation.