Preparation Before Operation; I Indoor Unit; I Remote Control; How To Operate - Panasonic CS-C9CKPG Manuel D'utilisation

PREPARATION BEFORE OPERATION

I Indoor Unit

5
2
4 3
1
Open the front panel
2
Remove the air filters
AUTOHEAT COOL DRY FAN
3
Fit the air purifying filters in place
AUTO
4
Insert the air filters
AUTO
FAN
5
Close the front panel
I Remote Control – To set the current time
AIR SWING
AUTO MANUAL
FAN SPEED
1 2 3
ON SET
OFF
CANCEL
TIMER
CHECK RESET CLOCK
1
Press 1.
2
Then press 2 to increase or decrease the time.
3
Press 1 again.
Set time will light up on display.
5

HOW TO OPERATE

1
I To start the operation
• Press 1.
• POWER indicator (green) on the indoor unit will light
up.
• To stop, press once more.
I Setting Mode
• Press 2 to select:-
2
1
2
3
5
1
6
4
Cooling Model
AUTO – Automatic Operation
COOL – Cooling Operation
DRY – Soft Dry Operation
(Dehumidifying Operation)
FAN – Air Circulation Operation
Heat Pump Model
AUTO – Automatic Operation
HEAT – Heating Operation
COOL – Cooling Operation
DRY – Soft Dry Operation
(Dehumidifying Operation)
I Setting Temperature
• Press 3 to increase or decrease the temperature.
• The temperature can be set between 16°C ~ 30°C.
• Recommended temperature :
Cooling Model Heat Pump Model
COOL –> 26°C ~ 28°C COOL –> 26°C ~ 28°C
DRY –> 1°C ~ 2°C
DRY –> 1°C ~ 2°C
lower than the
lower than the
room temperature
room temperature
HEAT –> 20°C ~ 24°C
• During AUTO Operation, press 3 to select:
• Operation with 2°C higher than the standard
temperature.
• Operation with the standard temperature.
• Operation with 2°C lower than the standard
temperature.
G Standard Temperature
Cooling Model
Indoor
Operation temperature
temperature
Cooling
23°C
Soft Dry
• Once the Automatic Operation is selected, the indoor
temperature sensor operates automatically to select
the desired operation mode with Cooling or Soft Dry.
• After the operation mode has been selected, the
mode does not change.
Heat Pump Model
Indoor
Operation temperature
temperature
Cooling
23°C Soft Dry
20°C
Heating
• At the beginning of the automatic operation, Heating,
Cooling or Soft Dry is automatically selected according
to the indoor temperature.
• The operation mode changes every hour, when
necessary.
Standard
25°C
22°C
Standard
25°C
22°C
21°C