Product Elements; Noise/Vibration Information; Intended Use; For Your Safety - Bosch DL 0 607 461 4 Serie Instructions D'emploi

All manuals and user guides at all-guides.com
PS_bu_3609929797_t.fm5 Seite 2 Mittwoch, 12. Juli 2000 11:45 11

Product Elements

1 Auxiliary handle
2 Tool holder
3 Housing
4 Clamping area
5 Exhaust air hose (combined)
for pistol configuration*
6 Air supply hose*
7 Hose connection piece
8 Air outlet with silencer of sintered metal
9 On-Off switch (rotation to the right)
10 On-Off switch (rotation to the left)
11 Allen screw for pressure sensing connection
12 Hanging hoop with support possibility*
13 Allen key 1/4"*
14 Round nut
15 Locking hook
16 Clutch
17 Allen key 10 mm*
*Optional accessories
Not all the accessories illustrated or described are in-
cluded in standard delivery.

Noise/Vibration Information

Measured values determined according to EN 50 144
(Rated pressure).
The A-weighted sound pressure level of the tool is typ-
ically 77 dB(A). The noise level when working can ex-
ceed 85 dB(A).
Wear ear protection!
The typical hand-arm vibration is below 2.5 m/s

Intended Use

The machine is intended for the screwing in and loos-
ening of bolts as well as for the tightening and loosen-
ing of nuts in the specified dimension and performance
range.
English–2

For Your Safety

Working safely with this machine is
possible only when the operating
and safety information are read
completely and the instructions
contained therein are strictly fol-
lowed.
In addition, the Section Safety In-
structions for Pneumatic Tools
must be observed.
Before using for the first time, ask
for a practical demonstration.
Disconnect the air supply.
s
Disconnect the air supply when the machine is not
in use, before maintenance work and for the
changing of the tools.
Check the direction of rotation setting
before operating the machine!
Keep hands away from the rotating tool holder as
s
well as the tool.
Use only flawless insertion tools that are not worn.
s
Defective insertion tools can cause injuries.
Pay attention to firm seating of the insertion tools!
s
Be careful in confined working conditions.
s
As a result of the reaction torque, injuries can occur
from squeezing or pinching.
Be careful when screwing in long bolts; danger of
s
sliding off.
Place the machine on the bolt/nut only when
s
switched off.
Secure the workpiece.
s
Use clamping devices or a vice to hold the work-
piece in place. In this manner, it is held more se-
2
.
curely than with your hand and makes possible the
operation of the machine with both hands.
Be careful of torque reaction!
s
For high torque settings and reduced operating
pressure, the clutch no longer disengages.
It is recommended that a auxiliary handle always be
s
used to reduce the danger of injury at high torques.
Bosch can assure flawless functioning of the ma-
s
chine only when original accessories are used.