Solution Tank - Hoover FloorMate SpinScrub Mode D'emploi

The tanks
Solution (upper) tank
The solution tank holds detergent and water that is to be dispersed onto the
surface being cleaned.
How to fill
Disconnect cleaner from electrical outlet.
Place cleaner handle in upright, locked position.
To remove tank, squeeze release button
17
and pull tank straight out.
Carry tank to a sink.
Rotate tank cap counter-clockwise and
18
lift up to remove cap (A).
Turn cap (A) upside down to serve as a measuring
19
cup.
For hard surface floors such as vinyl, linoleum, marble,
laminate wood, polyurethane sealed wood or other wood
floors that can normally be cleaned using water, use one
cup (2 oz.) HOOVER® Floor to Floor™ Cleaner.
Check for worn spots or joint separations before using,
as these conditions could lead to damaged flooring when
using water to clean floor.
NOTE: For cleaning ceramic and other tiles, some models
include a set of grout brushes with gray bristles. Use these
for tile floors where extra attention is needed for cleaning
grout. (See "Cleaning the brushes" section for how to
remove and replace the brush assemblies.)
Using cup, measure 1-1/2 cupfuls (3 oz.) of HOOVER®
Grout Cleaner*.
*Available at additional cost if not included with your
model.
17
18
A
19
Continued §
A
9