Storing stations
After locating a station, you can
store it as follows:
➔
Select the desired memory
bank (see page 23).
➔
Press the softkey for approx.
two seconds to which you
want to assign the station.
The station is stored. A signal
tone confi rms that the station
has been stored.
The display briefl y shows the
assignment of the six memory
locations of the current memo-
ry bank. The current station is
highlighted.
Note:
To automatically search for
FM stations and store them in
the FMT memory bank (Travel-
store), see page 28.
Listening to stored stations
➔
Select the desired memory
bank (see page 23).
➔
Briefl y press the softkey which
is assigned to the station you
want to set up.
The display may briefl y show
the assignment of the six mem-
ory locations of the current
memory bank. The current sta-
tion is highlighted. The desired
station is played back provided
All manuals and user guides at all-guides.com
➔
Scanning all receivable
stations (Scan)
➔
➔
Operating the tuner
that it can be received at the
current vehicle position.
Press the OK button
@
the ESC button
16 seconds.
The tuner display shows the
frequency and possibly the
name of this station, provided
that the station broadcasts this
RDS information.
In addition, the memory loca-
tion of the radio station
highlighted.
Select the waveband (FM, AM)
whose receivable stations you
want to scan (see page 27).
Press and hold the OK button
A
for approx. two seconds.
The tuner searches for stations
in the current waveband. The
display shows "SCAN" every
two seconds.
As soon as the tuner has locat-
ed a station, it is played and
the station name or the station
frequency appears on the dis-
play. The scan time can be set
as described on page 54 and
55 under "Scan Time".
After the frequency band has
been completely searched
once, the search stops and the
A
or
or wait for
D
is
25