Bosch GOP 12V-28 Professional Notice Originale page 8

All manuals and user guides at all-guides.com
OBJ_BUCH-3037-001.book Page 8 Tuesday, January 17, 2017 3:05 PM
8 | English
The following table shows examples for application tools. Further application tools can be found in the extensive Bosch acces-
sories program.
Accessory
BIM segment saw
blade
Base plate for
sanding, series
Delta 93 mm
Profile sander
BIM plunge cut
saw blade, wood
and metal
HCS plunge cut
saw blade, wood
Bi-metal plunge
cut saw blade,
hardwood
TC plunge cut saw
blade, metal
BIM plunge cut
saw blade, wood
and metal
HM-Riff segment
saw blade
Diamond-Riff seg-
ment saw blade
1 609 92A 2TY | (17.1.17)
Material Application
Wooden materials, Separating and plunge cuts; also for sawing close to
Plastic, edges, in corners and hard to reach areas;
Non-ferrous metals example: shortening already installed bottom rails or
door hinges, plunge cuts for adjusting floor panels
Depends on sanding sheet Sanding surfaces close to edges, in corners or hard to
reach areas;
depending on the sanding sheet for, e.g., sanding
wood, paint, varnish, stone
Fleeces for cleaning and for texturing wood, removing
rust from metal and for keying varnishes, polishing felt
for pre-polishing
Wood, Convenient, efficient sanding of profiles up to a diame-
Pipes/Profile, ter of 55 mm;
Paint, Red sanding sheets for sanding wood, pipes/profiles,
Varnishes, varnishes, fillers and metal
Filler,
Metal
Softwood, Smaller separating and plunge cuts;
Soft plastics, example: cutting an opening for sockets, flush cutting a
Plasterboard, copper pipe, plunge cuts in plasterboard
Thin-walled aluminium and
Filigree adjustment work in wood;
non-ferrous metal profiles,
example: sawing openings for locks and fittings
Thin sheet metals,
Non-hardened nails and
screws
Wooden materials, Separating and deep plunge cuts; also for sawing close
Soft plastics to edges, in corners and hard to reach areas;
example: narrow plunge cut in solid wood for installing
a ventilation grid
Hardwood, Plunge cuts in laminated panels or hardwood;
Laminated panels example: installing skylights
Metal, Plunge cuts in severely abrasive materials or metal;
Severely abrasive materials, example: cutting kitchen front covers, easy cutting
Fibreglass, through hardened screws, nails and stainless steel
Plasterboard,
Cement-bonded fibre boards
Softwood, Plunge cuts in laminated panels or hardwood;
Hardwood, example: shortening door frames, cutting openings for
Veneered panels, a shelf
Plastic-laminated panels,
Non-hardened nails and
screws
Cement joints, Cutting and separating close to edges, in corners or
Soft wall tiles, hard to reach areas;
Glass fibre reinforced plastics, example: removing grouting joints between wall tiles
Porous concrete for repair work, cutting openings in tiles, gypsum
boards or plastic
Cement joints, Precise routing and cutting of tile/joint material, epoxy
Soft wall tiles, resins and glass fibre reinforced plastics;
Epoxy resin, example: making smaller cutouts in soft wall tiles and
Glass fibre reinforced plastics routing openings in glass fibre reinforced plastic
Bosch Power Tools