Foppapedretti Lift Mode D'emploi page 16

• ENGLISH •
All manuals and user guides at all-guides.com
USE
Attach the two tabs to the buckle. Make sure that the child is correctly restrained by the strap and that it is
adjusted to the correct size.
IMPORTANT: The harness must only be used with all the components attached.
IMPORTANT: Adjust the harness correctly each time the HIGH CHAIR is used.
SAFETY STRAP ASSEMBLY/DISASSEMBLY
(fig. 23-29)
Remove the safety strap; rotate the end with the stitched turn-up (a) to secure the "lap" safety strap and pull
out the strap from the inside of the seat, through the slots in the seat shell. Rotate the end with the stitched
turn-up (b) to secure the "crotch" safety strap and pull out the strap from the inside of the seat, through the
slots in the seat shell and the padding.
Assemble the safety strap; completely insert the end with the stitched turn-up (c) of the "crotch" safety strap
through the fabric slots and the corresponding slots in the seat shell. If necessary, use a flat-head tool. Rotate
the end of the strap, which is protruding from the slots in the shell (d). Make sure that it is assembled and locked
correctly. When pulling the safety strap from the inside of the seat, it should not slip through the slots.
Completely insert the end with the stitched turn-up (e) of the "lap" safety strap through the corresponding slots
in the seat shell. If necessary, use a flat-head tool. Rotate the end of the strap, which is protruding from the slots
in the shell (f). Make sure that it is assembled and locked correctly. When pulling the safety strap from the inside
of the seat, it should not slip through the slots.
CLOSING
(fig. 30-33)
Remove the child from the booster chair.
Unclip the buckles on the backrest and seat fixing strap to remove the product from the adult chair.
Press the buttons on the underside of the seat, as shown in the figure (fig. 30) and lift up the seat while keeping
them pressed down.
Unhook the padded part of the backrest secured with veltro and fold it over the tray.
Press the (a) buttons simultaneously and fold down the side armrests (fig. 31).
Press the closing lock button (b) and, holding it down, press both (c) buttons to close the shell (fig. 32-33).
PLACING THE BOOSTER ON THE ADULT CHAIR
(fig. 34-36)
Place the product on a stable adult chair (Fig. 34). Make sure the booster chair is in a central position and does
not protrude from the front or sides of the chair (refer to the warnings in this manual for further information).
Use the booster chair with an adult chair that has the minimum dimensions required and shown in figure (34), a
seat of at least 400 mm in width and 340 mm in length, and a backrest of at least 350 mm.
Attach the rear fastening strap (Fig. 35) by passing it behind the backrest of the adult chair and pass the lower
fastening strap around the seat (Fig. 36). Make sure that you hear a "click" to indicate that it has attached
correctly.
Pull the free end of the rear and lower strap to secure the booster to the adult chair.
After correctly attaching the booster to the adult chair, the child can be placed in it.
ATTENTION: Make sure that the straps securing the booster to the adult chair are not twisted.
ATTENTION: Make sure that the straps securing the booster to the adult chair are always taut before using the
product.
REMOVING THE PADDING FOR WASHING
• Remove the padding's strap, see paragraph "Assembling the padding"
• Remove the crotch safety strap from the padding, see paragraph "Safety strap assembly/disassembly".
16