Care And Cleaning; Periodic Cleaning; Periods Of Non-Operation - Electrolux SC300 Notice D'utilisation

66 www.electrolux.com
air that falls down. It may result in that
food with high water content start to
freeze. If too cold, change to a higher
temperature setting.
Do not place food against or close
to the temperature sensor (A) or
any shelves towards the water
drain hole. This can result in too
cold temperatures.

5. CARE AND CLEANING

CAUTION!
Unplug the appliance before car-
rying out any maintenance opera-
tion.
This appliance contains hydrocar-
bons in its cooling unit; mainte-
nance and recharging must there-
fore only be carried out by author-
ized technicians.

5.1 Periodic cleaning

The equipment has to be cleaned regular-
ly:
• clean the inside and accessories with
lukewarm water and some neutral
soap.
• regularly check the door seals and wipe
clean to ensure they are clean and free
from debris.
• rinse and dry thoroughly.
Do not pull, move or damage any
pipes and/or cables inside the
cabinet.
Never use detergents, abrasive
powders, highly perfumed clean-
ing products or wax polishes to
clean the interior as this will dam-
age the surface and leave a
strong odor.
All manuals and user guides at all-guides.com
A
• If you want to check the temperature of
food stored in the refrigerator, place a
glass of water centrally in the cabinet,
and put a proper thermometer with an
accuracy of +/– 1 °C into it. After 6
hours the temperature can be moni-
tored. The measuring shall be per-
formed under steady-stated conditions
(without changing the load).
Clean the condenser (black grill) and the
compressor at the back of the appliance
with a brush. This operation will improve
the performance of the appliance and
save energy consumption.
Take care of not to damage the
cooling system.
When moving the cabinet, lift it by
the front edge to avoid scratching
the floor.
Many proprietary kitchen surface cleaners
contain chemicals that can attack/dam-
age the plastics used in this appliance.
For this reason use a soft cloth rinsed in
warm water and neutral soap emulsion for
cleaning external surfaces.
Do not use detergents or abrasive
paste as these will damage the
paint, or stainless steel anti finger
print coating.
After cleaning, reconnect the equipment
to the mains supply.

5.2 Periods of non-operation

When the appliance is not in use for long
periods, take the following precautions: