Keyboard Sound Turn On / Off; Call Up Operating Data - OHAUS Frontier FC5513 Manuel D'instructions

EN-16
A-1
5
6
4.1.6

Keyboard sound turn on / off

Proceed as described under point 4.1.2 to enter this program mode and then press the key "Accel/Decel" (6). In the
display "Acc/Dec" (A-2) the word "Service" flashes. Now select the letter "B". with the adjusting dial (4). As a result,
in the display "RPM/RCF" (A-1), the word "ON/BEEP " appears. After pressing the key "RPM/RCF" (5), you can
turn the keyboard sound (On) or (Off) with the adjusting dial (4). (See figure 33).
After you have stored the settings (See 4.1.2) you can change back to the normal program mode again by switch off
the centrifuge for a short while.
A-1
5
6
4.1.7 Sleep Mode On / Off
After not using the centrifuge for 5 minutes, the display automatically switches off. By pressing any bottom, it
switches on again. Proceed as illustrated, under point 1.8.2, to enter this program mode, press the key,
"accel/decel" (5). In the display, "accel/decel" (A-2) flashes the word, "service". Select the letter "I" with the control
field (1). As a result, appearing in the display, "rpm/rcf" (A-1), the word "SLEEP". After pressing the key, "rpm/rcf"
(4), turn the sleep mode function (On) or (Off), with the rotorary field (1).
After the settings have been stored by user, the normal program mode can be changed back again by switching off
the centrifuge, for a short period.
4.1.8

Call up operating data

ATTENTION:
This should only be performed by advance user or service engineer.
A-2
Figure. 32
A-2
Figure. 33
TM
Frontier Centrifuge FC5513
4
4