Signal Turn On / Off; Volume Pre-Selection Of Sound Signal - OHAUS Frontier FC5513 Manuel D'instructions

Masquer les pouces Voir aussi pour Frontier FC5513:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

TM
Frontier
Centrifuge FC5513
4.1.3

Signal turn on / off

Proceed as described under point 4.1.2 to enter this program mode and then press the key "Accel/Decel" (6). In the
display "Acc/Dec" (A-2) the word "Service" flashes. Now select the letter "L" with the adjusting dial (4). As a result,
the words "On Sound" appears in the display "RPM/RCF" (A-1). If you press the key "RPM/RCF" (A-1) now, the
word "On" flashes and you can switch off the sound with the adjusting dial (4) (See figure 30).
After you have stored the settings (See 4.1.2) you change back to the normal program mode again by switching off
the centrifuge for a short while.
A-1
5
6
4.1.4

Volume pre-selection of sound signal

Proceed as described under point 4.1.2 to enter this program mode and then press the key "Accel/Decel" (6). In the
display "Acc/Dec" (A-2) the word "Service" flashes. Now select the letter "U" with the adjusting dial (4). As a result,
in the display "RPM/RCF" (A-1) the words "Vol=0- 9/Sound" appear. After pressing the key "RPM/RCF" (5), you
can adjust the desired volume between 0 (low) and 9 (loud) with the adjusting dial (4) (See figure 31).
After you have stored the settings (see 4.1.2) you can change back to the normal program mode again by switching
off the centrifuge for a short period.
A-1
5
6
4.1.5
Song selection for sound signal - end of run
Proceed as described under point 4.1.2 to enter this program mode and then press the key "Accel/Decel" (6). In the
display "Acc/Dec" (A-2) the word "Service" flashes. Now select the letter "G". with the adjusting dial (4). As a
result, in the display "RPM/RCF" (A-1), the word "SonGo/Sound" appears. After pressing the key "RPM/RCF" (5),
you can select a song with the adjusting dial (4). (See figure 32).
After you have stored the settings (See 4.1.2) you can change back to the normal program mode again by
switch off the centrifuge for a short while.
A-2
Figure. 30
A-2
Figure. 31
EN-15
4
4

Publicité

Table des Matières
loading

Table des Matières