Song Selection For Sound Signal - End Of Run; Keyboard Sound Turn On / Off - OHAUS Frontier FC5707 Manuel D'utilisation

EN-14
A-1
5
6

4.4 Song selection for sound signal - end of run

Proceed as described under point 4.1.2 to enter this program mode and then press the key "Accel/Decel" (6). In
the display "Acc/Dec" (A-2) the word "Service" flashes. Now select the letter "G". with the adjusting dial (4). As a
result, in the display "RPM/RCF" (A-1), the word "SonGo/Sound" appears. After pressing the key "RPM/RCF" (5),
you can select a song with the adjusting dial (4). (See figure 31).
After you have stored the settings (See 4.1) you can change back to the normal program mode again by
switch off the centrifuge for a short while.
A-1
5
6

4.5 Keyboard sound turn on / off

Proceed as described under point 4.1.2 to enter this program mode and then press the key "Accel/Decel" (6). In
the display "Acc/Dec" (A-2) the word "Service" flashes. Now select the letter "B". with the adjusting dial (4). As a
result, in the display "RPM/RCF" (A-1), the word "ON/BEEP " appears. After pressing the key "RPM/RCF" (5),
you can turn the keyboard sound (On) or (Off) with the adjusting dial (4). (See figure 32).
After you have stored the settings (See 4.1) you can change back to the normal program mode again by switch off
the centrifuge for a short while.
A-2
Figure. 30
A-2
Figure. 31
TM
Frontier Centrifuge FC5707
4
4