gourmetmaxx GLA-1003 Mode D'emploi page 27

1. Slide one of the rotating spit forks onto the shaft and lock it with the locking screw.
The shaft contains a small round notch for the tip of the locking screw. In the case of
smaller pieces of food, the rotating spit forks can be secured more centrally on the
shaft (see Illustration A).
2. Slide the items you want to grill onto the rotating spit fork.
3. Slide the other rotating spit fork onto the shaft and food and lock it with the locking
screw.
4. Plug one end of the shaft into the round holder (11) on the left-hand side of the
cooking space (10). Then hang the other end of the shaft into the support (9) on the
right-hand side of the cooking space.
5. Check that it fi ts securely. The rotating spit must not be able to rotate about its own
axis when the device is switched off . If this is not the case, plug the left-hand end of
the shaft deeper into the holder.
After use, remove the hot rotating spit from the cooking space using the removal tool (5)
(see the "Removal Tool" section). Always use oven gloves to remove the rotating spit
forks and take off the grilled items.
Rotating Basket
In the rotating basket (2), the food is rotated during cooking so that it becomes crispy on
all sides. The rotating basket is particularly suitable for preparing chips or other potato
products, small pieces of vegetables and meat as well as frozen products, e.g. chicken
nuggets or squid rings.
Fill the rotating basket and insert it into the device:
1. Open the fl ap of the rotating basket (see Illustration B).
2. Fill the rotating basket with food. It should not be too full to ensure that the food is
cooked evenly.
3. Close the fl ap and ensure that it is shut correctly so that it does not open during use.
4. First insert the left-hand side with the L marking of the rotating basket into the cooking
space (10). To do this, plug the left end (with just one notch) of the shaft as far as it will
go into the round holder (11) on the left-hand side of the cooking space. Then hang
the other end (with two notches) of the shaft into the support on the right-hand side of
the cooking space (see Illustration C).
5. Check that it fi ts securely. The rotating basket must not be able to rotate about its own
axis when the device is switched off . If this is not the case, plug the left-hand end of
the shaft deeper into the holder.
After use, remove the hot rotating basket from the cooking space using the removal tool
(see the "Removal Tool" section). Always use oven gloves to open and empty the rotating
basket.
Removal Tool
The hot rotating basket or rotating spit is taken out of the cooking space using the re-
moval tool (5).
1. Place the ends of the removal tool under the shaft (see Illustration D).
2. First lift up the right-hand side of the shaft and move it forwards a little until the left
end of the shaft is released from the holder.
3. Carefully lift the rotating basket or rotating spit out of the cooking space (10) and
place down on a heat-resistant surface.
04888_Inlay_DE-EN-FR-NL_A5_V1.indb 27 04888_Inlay_DE-EN-FR-NL_A5_V1.indb 27
27 EN
11.12.2019 15:15:25 11.12.2019 15:15:25