Assemble The Light On Ceiling Tube; Assembly Of Visiano 20-2 P Tx; Load Data; Assembly - Derungs Dmed VISIANO 20-2 C T1 Mode D'emploi

Tighten M8 safety screw and nut 1 (20 Nm /

14.75 lbf ft)
Tighten all 4 threaded pins 2 (5 Nm / 3.68 lbf ft)

DANGER
Mortal danger from electric shock

Disconnect from the power supply and secure
against unintended switching on before starting
work on the power connection.

Make power connection

Connect the secondary cable to the connection
point

Pay attention to the polarity:
+ = red → Connect the brown cable
– = blue → Connect the blue cable

Push cover and end ring over the ceiling bracket
and tighten them (0.5Nm)
3.3 Assemble the light on ceiling
tube
WARNING
The light will fall
incorrectly

The securing element must be screwed in fully
and correctly.
if fastening is done

Insert the light and the adapter 1 into the ceiling
tube 2
Insert securing element with threated pin 3 and

screw in to the stop

Loosen by one quarter-turn to ensure the
operation of the turnover axis
4 ASSEMBLY of
VISIANO 20-2 P TX
4.1

Load data

Bending moment M
B
Vertical weight F
G
4.2

Assembly


The lights are equipped with an adapter pin.
The light must be positioned in one of the
accessories described in chapter 9.
5

OPERATION

5.1

VISIANO 20-2 C T1

DANGER
Electric shocks are life-threatening

Only connect to a mains power supply with a
protective conductor
5.2 VISIANO 20-2 C T1
VISIANO 20-2 P TX
DANGER
Electric shocks are life-threatening

Do not insert any power cable that is damaged.

If there is any sign of damage to the power
cable, replace it immediately with a new one.

The connection voltage and frequency must
match the data on the type plate.
WARNING
Risk of eye damage

Never look directly into the beam of light.
ENG
25Nm
20N
21