Derungs Dmed VISIANO 20-2 C T1 Mode D'emploi page 20

ENG
Insert ceiling tube 1 into ceiling bracket 2 and

drill with d= 9mm 3. Use the existing hole in the
ceiling bearing as a guide.

Make 4 opposited drill hole markings (Ø13mm),
note the position of the Ø60mm drill hole for
electrical connections

Check clearances
DANGER
Risk of injury from falling parts

The ceiling bracket must be secured to the
fastening material, which must be suitable for
the corresponding ceiling condition.
DANGER
Risk of injury from falling parts

Mounting must be performed by two people.
CAUTION
Use protective equipment in line with the tool
manufacturer's instructions

Drill the bore holes, then blow them out using
bellows
20
DANGER
Risk of injury from falling light

The ceiling must be made of solid concrete to
guarantee a secure hold.

Use suitable ceiling anchors.

Disassemble the securing element from the
ceiling tube (Allen wrench is enclosed; do not
lose the threated pin!)

Insert the cable (with loose ends first) and pull
up to the stop

Pull the light cable of the ceiling tube through
the light mount.

Insert ceiling tube into light mount
Secure using the M8 safety screw and nut 1


Hold the ceiling bracket against the ceiling and
strike the ceiling anchor with a hammer

Tighten fastening in line with manufacturer's
data