Cleaning The Appliance; Proceed As Follows - Bosch KDN Serie Notice D'utilisation

Cleaning the appliance

m
Caution
Do not use abrasive, chloride or acidic
■
cleaning agents or solvents.
Do not use scouring or abrasive
■
sponges.
The metallic surfaces could corrode.
Never clean shelves and containers
■
in the dishwasher.
The parts may become deformed!
The cleaning water must not get into
the following areas:
Controls
■
Illumination
■
Ventilation openings
■
Openings in the separating plate
■

Proceed as follows:

1. Pull out the mains plug or switch off
the fuse.
2. Take out the frozen food and store
in a cool location. Place ice pack (if
available) on the food.
3. The rinsing water must not drip into
the controls, lighting, ventilation
openings or the openings in the
partition!
Clean the appliance with a soft cloth,
lukewarm water and a little pH-neutral
washing-up liquid.
4. Wipe the door seal with clear water
only and then wipe dry thoroughly.
5. After cleaning reconnect the
appliance.
6. Put the frozen food back into
the appliance.
All manuals and user guides at all-guides.com
Interior fittings
All variable parts of the appliance
can be taken out for cleaning.
Take out shelves in the door
Fig. #
Lift shelves upwards and take out.
Take out glass shelves
Pull the glass shelves forwards and take
out.
Removing the container
Fig. (
Pull out the container all the way, lift at
the front and remove.
Taking out glass shelf above vegetable
container
Fig. -
The glass shelf can be taken out and
disassembled for cleaning.
Note
Before taking out the glass shelf, pull out
vegetable container.
Cleaning the ice maker
Clean the ice maker regularly. This will
prevent ice cubes, which were made
quite a long time ago, from shrinking,
having a stale taste or sticking together.
Fig. ,
1. Remove and empty the ice cube tray
and storage container.
2. Press the push-button to release the
ice maker from the holder.
3. Remove the ice maker.
4. Lift the rear end of the holder and
lower behind the glass plate.
5. Remove the holder towards the front.
6. Clean all parts of the ice maker with
warm water.
7. Allow all parts to dry completely.
8. Assemble the ice maker in reverse
order and insert.
en
19