Switching On The Appliance; Operating Tips - Bosch KDN Serie Notice D'utilisation

en
11
freezer/fridge button to select a
section
Used to select a section. This is
necessary to change its
temperature or to switch on
certain special functions.
12
Setting buttons +/-
The buttons are used to set the
temperatures of the refrigerator
and freezer compartment.
13
Status indicator
Lights up red if an alarm is active.
This happens if the appliance
gets too hot inside.
Lights up white when the control
panel switches to standby mode.
14
lock button
Switches the button lock function
on. If this function is switched on,
no settings are possible via the
controls.
15
Button lock function display
Indicates whether the button lock
is switched on or off.
n The control panel is locked.
o The control panel is unlocked.
16
Super button
Used to switch on the functions
supercool (fridge compartment)
and superfreeze (freezer
compartment).
10
All manuals and user guides at all-guides.com
Switching on the
appliance
1. First insert the plug into the
connection on the back of the
appliance. Check that the plug has
been inserted all the way.
2. Then insert the other end of the cable
into the socket.
The appliance is now switched on and a
warning signal sounds.
Press the freezer/fridge button to switch
off the audible warning signal.
The – ALARM – display goes out when
the appliance has reached the set
temperature.
The preset temperatures are reached
after several hours. Do not put any food
in the appliance beforehand.
The factory has recommended
the following temperatures:
Freezer compartment: -18 °C
■
Refrigerator compartment: +4 °C
■

Operating tips

After the appliance has been switched
■
on, it may take several hours until the
set temperatures have been reached.
The fully automatic NoFrost system
■
ensures that the freezer section
remains free of ice. Defrosting is no
longer required.
If the door cannot be immediately re-
■
opened after it has been closed, wait
until the resulting low pressure has
equalised.
The front and side panels
■
of the housing are partly heated
slightly.This prevents condensation
from forming.