Assembly And Adjustment - Black & Decker LSTE522 Mode D'emploi

INSTALLING AND REMOVING
THE BATTERY PACK FROM THE
APPLIANCE
WARNING:
Make certain the lock-off button is not
engaged to prevent switch actuation before removing or
installing battery.
TO INSTALL BATTERY PACK: Insert battery (13) into
appliance until an audible click is heard (Figure B).
Ensure battery pack is fully seated and fully latched into
position.
TO REMOVE BATTERY PACK: Depress the battery release
button (14) as shown in Figure C and pull battery pack out
of appliance.
B
C
SAVE THESE INSTRUCTIONS

ASSEMBLY AND ADJUSTMENT

WARNING:
BEFORE ASSEMBLY, MAKE SURE
THAT THE APPLIANCE IS SWITCHED OFF AND THE
BATTERY HAS BEEN REMOVED.
ASSEMBLY TOOLS REQUIRED
(NOT SUPPLIED):
- Phillips Screwdriver
INSTALLING THE GUARD
WARNING:
REMOVE THE BATTERY FROM
THE APPLIANCE BEFORE ATTEMPTING TO
ATTACH THE GUARD, EDGE GUIDE OR HANDLE.
NEVER OPERATE APPLIANCE WITHOUT GUARD
FIRMLY IN PLACE. THE GUARD MUST ALWAYS
BE ON THE APPLIANCE TO PROTECT THE USER.
• Remove the screw from the guard.
• Turn the trimmer upside down so that you are looking
down at the spool cap (15).
13
14
• Turn the guard (11) upside down and slide it fully onto
the motor housing (16). Make sure the tabs (17) on the
guard engage the ribs (18) on the motor housing as
shown.
• Continue to slide the guard on until you hear it "snap"
into place. The locking tab (19) should snap into the
housing slot (20).
11
D
17
• Using a phillips screwdriver, insert the guard screw
and tighten securely as shown in Figure E to
complete the guard assembly.
• Once the guard is installed, remove the covering
from the line cut-off blade, located on the edge of
the guard
E
ATTACHING THE AUXILIARY HANDLE
To attach the handle, press in on the buttons (21) on both
sides of the upper housing as shown in figure F.
F
• Position the handle as shown in figure G (with the
BLACK+DECKER logo facing upward). Partially push
the handle on so it will hold the buttons in when
you release them with your hand.
6
19
20
16
18
15
21