Switching On And Off - Black & Decker LST136 Mode D'emploi

Masquer les pouces Voir aussi pour LST136:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

edging mode to trim overhanging
grass along lawn edges and flower
beds as shown in figure K.
TRIMMING MODE
For trimming, the trimmer head
should be in the position shown in
figure I. If it is not:
• Remove the battery from the tool.
• Press and hold the head release
button (I1).
• While holding the auxillary handle,
rotate the head clockwise.
• Release the head release button.
• Lift the edge guide (J1) into the
closed position.
Note: The head will only rotate in one
direction.
CAUTION:
Wire edge guide
should only be used when in the
edging mode. Keep wire edge guide
in the retracted position when in the trimming mode.
EDGING MODE (FIGURE K)
WARNING
:
When being used as an Edger, stones, pieces of
metal and other objects can be thrown out at high speed by the line. The
trimmer and guard are designed to reduce the danger. However, MAKE
SURE that other persons and pets are at least 100 feet (30m) away.
For edging, the trimmer head should be in
the position shown in figure K. If it is not:
• Remove the battery from the tool.
• Press and hold the head release
button (K1).
• While holding the auxillary
handle, rotate the head
counterclockwise.
• Release the head release button.
• Drop the edge guide (K2) in to
I
I1
J
J1
K
K1
K2
the open position. Ensure that the edging guide is all the way down,
an audible click will be heard.
Note: The head will only rotate in one direction.
Note: The auto Feed System may not operate correctly if edge guide is not used.

SWITCHING ON AND OFF

• To switch the tool on, press
in and hold the lock off button
(L1) then squeeze the trigger
lever (L2). Once the tool is
running you may release the
lock off button (L1).
• To switch the tool off, release
the trigger lever.
WARNING:
Never attempt
to lock the trigger lever in the
on position.
POWER COMMAND - MAX POWER / MAX RUNTIME
The max power / max runtime
feature (M1) is located on the
tool handle. It allows you to
optimize the tools performance
and boost the power as needed.
• To choose max power to
tackle thick weeds, rotate dial
to setting 6.
• To choose max runtime to
increase battery life rotate dial
to setting 1.
• For a combination of both,
rotate dial to setting from 2 to 5.
9
L
L1
L2
M
M1

Publicité

Table des Matières
loading

Table des Matières