Toshiba MMU-AP0091H Manuel Du Propriétaire page 10

Operation section
Push each button to select a desired operation.
This remote controller can operate the maximum 8 indoor units.
• The details of the operation needs to be set up once, afterward, the air conditioner can be used by pushing
button only.
2
3
4
5
1
Air volume select button
Selects the desired air volume mode.
The Concealed Duct High Static Pressure type
models cannot be operated.
2
Timer set button
TIMER SET button is used when the timer is
set up.
3
Check button
The CHECK button is used for the check
operation. During normal operation, do not
use this button.
4
Fan button
FAN button is used when a fan which is sold on
the market or etc. is connected.
• If is displayed on the remote controller
when pushing the FAN button, a fan is not
connected.
5
Filter reset button
Resets (Erases) "FILTER
6
Wind direction and Swing
:
UNIT
If the multiple indoor units are operated by only
one remote controller, select the units when
the air direction is adjusted.
:
Set up the auto swing and angle of the flap.
• This function is not provided to Concealed
Duct Standard Type, High Static Pressure
Type, Floor standing Cabinet Type, or Floor
Standing Concealed Type.
All manuals and user guides at all-guides.com
1
SET CL
6
" display.
7
7
UNIT
7
Operation lamp
Lamp is lit during the operation. Lamp is off
when stopped.
Although it flashes when operating the protec-
tion device or abnormal time.
8
button
When the button is pushed, the operation
starts, and it stops by pushing the button
again.
When the operation has stopped, the operation
lamp and all the displays disappear.
9
Operation select button
Selects desired operation mode.
10
Set up temperature button
Adjusts the room temperature.
Set the desired set temperature by pushing
or
Remote controller sensor
Usually the TEMP . sensor of the indoor unit senses
the temperature. The temperature on the surround-
ing of the remote controller can also be sensed.
For details, contact the dealer from which you have
purchased the air conditioner.
• In case that one remote controller controls the
multiple indoor units, the setup operation is
unavailable in group control.
8
9
10
.