Avtek TT-BOARD 3000 Notice D'utilisation page 11

1. Contents of the container
After opening the package, verify its contents. If any parts mentioned below are of damaged or missing,
please contact the seller.
Contents:
Model 3000/4000
Interactive whiteboard
USB cable
Warranty card
Instruction manual
Pens
Wall-mounting kit
Note:
The surface of Avtek TT-BOARD 3000/4000 interactive whiteboard has been optimized for the best possible
image from the projector and the elimination of the glare resulting from light reflection. For this purpose, a
special surface coating was used. In order to maintain high-quality performance of the whiteboard, wipe it
immediately after making notes with dry-erase pens. It is also recommended to clean its surface on a regular
basis using household cleaners for dry-erase whiteboards.
• Clean the whiteboard regularly or whenever you notice that the dry-erase ink remains on the whiteboard
surface after wiping
• Do not use permanent pens or others, unsuitable for dry-erase surfaces
• In the case of non-compliance with the manufacturer's instructions, the surface can become permanently
dirty
System requirements:
Minimum system requirements:
Processor
1.0 GHz x86
Memory
256 MB
Graphics card
at least 256 colours
Hard drive – free space 150 MB
Screen resolution 800x600, 1024x768,
1280x1024
USB port 1.1
The Avtek interactive whiteboard is a Human Interface Device (HID); therefore, once connected to the USB
port, it is automatically detected and installed by the system. As a result, it is not necessary to install dedicated
drivers. MS Windows 7 (and higher) operating systems have built-in tool that allows the calibration process
(see Point 5 for more details).
All manuals and user guides at all-guides.com
Name of the part Qua Information
1 Respective model
1
1
1
2
1
Recommended system parameters:
Processor
Memory
Graphics card
Hard drive – free space
Screen resolution
USB port
9
2.0 GHz x86
512 MB or more
256 colours or more
500 MB
1024x768, 1280x1024
2.0