Technical Data - AEG ATC1521 Notice D'utilisation

60 www.aeg.com
Problem
The temperature in
the refrigerator is
too high.
7.1 Replacing the lamp
7.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".

8. TECHNICAL DATA

Dimension
Voltage
Frequency
The technical information are situated in
the rating plate on the internal left side
of the appliance and in the energy label.
Possible cause
There is no cold air circu-
lation in the appliance.
1.
2.
3.
4.
5.
6.
7.
8.
3.
Height
Width
Depth
Solution
Make sure that there is
cold air circulation in the
appliance.
Disconnect the mains plug from the
mains socket.
Remove the screw from the lamp
cover.
Remove the lamp cover (refer to the
illustration).
Replace the used lamp with a new
lamp of the same power and specifi-
cally designed for household appli-
ances. (the maximum power is
shown on the lamp cover).
Install the lamp cover.
Tighten the screw to the lamp cover.
Connect the mains plug to the mains
socket.
Open the door. Make sure that the
lamp comes on.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
850 mm
595 mm
635 mm
230 V
50 Hz