AEG ATC1521 Notice D'utilisation page 64

64 www.aeg.com
9.7 Door reversibility
4
2
1
1
2
To carry out the following opera-
tions, we suggest that this be
made with another person that
will keep a firm hold on the doors
of the appliance during the oper-
ations.
To change the opening direction of the
door, do these steps:
• Remove the plug from the power
socket.
• Tilt back the appliance carefully so
that the compressor cannot touch the
floor.
• Unscrew the left foot.
• Unscrew the screws of the door bot-
tom hinge.
• Take off the appliance door by pulling
it slightly downwards.
• Unscrew the top door hinge pin of the
appliance then screw it back on the
other side.
• Remove the lower hinge. Put over the
pin in the direction of the arrow.
• Fit the appliance door on the upper
door hinge pin.
• Unscrew and install the screw on the
opposite side.
• Install the lower hinge on the opposite
side leaving the position of the door
unchanged.
• Screw in the one screw in the place set
free on the other side as well as the
right foot.
• Remove and install the handle (if fore-
seen) on the opposite side.
• Reposition, level the appliance, wait
for at least four hours and then con-
nect it to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
3