Troubleshooting - Electrolux ERN3001FOW Notice D'utilisation

10 www.electrolux.com
Defrost the freezer when the frost layer
reaches a thickness of about 3-5 mm.
1. Pull out the plug from the wall socket
or switch off the appliance.
2. Remove any stored food, wrap it in
several layers of newspaper and put it
in a cool place
CAUTION!
Do not touch frozen
goods with wet hands.
Hands can freeze to the
goods.
3. Open the door.
In order to speed up the defrosting
process, place a pot of warm water in
the freezer compartment. In addition,
remove pieces of ice that break away
before defrosting is complete.
4. When defrosting is completed, dry the
interior thoroughly.
5. Switch on the appliance.
6. Set the temperature regulator to
obtain the maximum coldness and run

7. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
The appliance does not op-
erate.
The appliance is noisy.
The compressor operates
continually.
All manuals and user guides at all-guides.com
Possible cause
The appliance is switched
off.
The mains plug is not
connected to the mains
socket correctly.
There is no voltage in the
mains socket.
The appliance is not sup-
ported properly.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
the appliance for two or three hours
using this setting.
7. Reload the previously removed food
into the compartment.
6.5 Periods of non-operation
When the appliance is not in use for long
periods, take the following precautions:
• Disconnect the appliance from
electricity supply
• Remove all food
• Defrost (if foreseen) and clean the
appliance and all accessories
• Leave the door/doors open to prevent
unpleasant smells.
If the cabinet will be kept on,
ask somebody to check it
once in a while to prevent the
food inside from spoiling in
case of a power failure.
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electrical
appliance to the mains sock-
et. Contact a qualified electri-
cian.
Check if the appliance stands
stable.
Refer to "Operation" chapter.
Wait some hours and then
check the temperature again.