Electrical Connection - Miele PW 6241 EL Schéma D'installation

The washing machine must be set up on a completely level, horizon-
tal, and firm surface with the minimum stated load bearing capacity
(see "Technical data").
Tip: A concrete floor is the most suitable installation surface for this
machine. It is far less prone to vibration during the spin cycle than
wooden floorboards or a carpeted surface.
The floor load created by the washing machine is the load exerted
by the area of the machine in contact with and transferred to the in-
stallation footprint.
The washing machine requires a gap of at least 2" (50 mm) at each
side to allow for movement during operation. Please ensure a mini-
mum distance of 70 7/8" (1,800 mm) is maintained between the ma-
chine front and the rear wall. Refer to installation diagrams for more
information.
The washing machine must not be installed on a carpeted floor.
The feet of the washing machine must be secured to the 4 fastening
points on the floor using the fixtures and fastenings supplied.
The material provided is intended for use in bolting the machine to a
concrete floor. If other floor types are present at the installation site,
the fastening material must be ordered by the customer.
The base frame of the washing machine contains four drilled holes
through which it is possible to drill into the floor.

Electrical connection

The electrical connection must only be carried out by a qualified
electrician who must ensure that all electrical work is carried out in
accordance with applicable electrical regulations and standards.

The washing machine must be connected to an electrical supply
that complies with local and national regulations. Please also observe
your insurance and energy supplier's regulations as well as any health
and safety at work regulations.

The required voltage, power consumption and specifications for
external fusing are quoted on the data plate on the washing machine.
Ensure that the supply voltage complies with the voltage quoted on
the data plate before connecting the washing machine to the power
supply.
Connection to a supply voltage other than the one quoted on the
data plate can lead to functional faults and damage the washing
machine.
If more than one voltage is quoted on the data plate, the washing
machine can be converted for connection to the voltages stated.
en - Installation notes
5