Utilisation d'un manteau non combustible inférieur aux dégagements
énumérés
Chaque foyer à gaz a un ensemble unique d'exigences en matière de cheminée. Si vous souhaitez
placer un manteau incombustible à une hauteur inférieure à celle spécifiée dans ce manuel, il devra
répondre aux exigences suivantes:
L'en-tête (l'élément de charpente au-dessus de l'ouverture du foyer) doit être incombustible.
Le revêtement doit être incombustible et s'étendre au collecteur (ou au manteau, selon la valeur
la plus grande). Le parement doit également couvrir toute la largeur du manteau.
Voir l'illustration ci-dessous pour des exigences supplémentaires.
SIDE VIEW
Non-Combustible Framing (metal studs)
must be used for the header.
Non-Combustible Facing and Non-Combustible Backing Material
(tile, marble, cement board, etc.) must extend to the header (or top
of mantel - whichever is higher)
Non-Combustible Mantel and Mantel Legs
(no maximum depth) - No combustible
TOP VIEW
Non Combustible Framing (metal studs)
must extend the full width of the mantel
and mantel legs.
© Travis Industries
Installation
Facing from the Header Up
may be combustible (drywall)
or non-combustible.
materials allowed behind the mantel.
Fireplace Face
(for qualified installers only)
Gas Fireplace
Gas Fireplace
6/1/2020 – 1425-FR
41
Minimum Mantel Height
The minimum mantel
height is determined by
the face and face
attachment method (no
minimum). The mantel
must be properly
secured to the framing or
use other suitable
method.
Combustible Framing
(wood studs) may be
used for the framing
behind the fireplace.
Non Combustible Facing
(tile, marble, cement board, etc.) must
extend the full width of the mantel.
Non Combustible Mantel and Legs
4415HO ST