Makita 6905B Manuel D'instructions page 5

For tool with firm fit detent pin
1
2
2
4
007322
To install the socket, align the hole in the side of the
socket with the detent pin on the anvil.
Push the socket onto the anvil until it snaps into place.
Tap it lightly if required.
To remove the socket, depress the detent pin through the
hole in the socket and pull the socket off the anvil.
For model 6906
1
2
002338
N.m
002348
1. Socket
2. Anvil
3. Hole
3
4. Detent pin
4
1. Socket
2. Anvil
(ft.lbs)
400
(258)
300
(216)
200
(144)
100
(72)
0 1 2
To install the socket, push it onto the anvil of the tool until
it locks into place.
To remove the socket, simply pull it off.
For socket with O-ring and pin
1
005300
Move the O-ring out of the groove in the socket and
remove the pin from the socket. Fit the socket onto the
anvil of the tool so that the hole in the socket is aligned
with the hole in the anvil. Insert the pin through the hole in
the socket and anvil. Then return the O-ring to the
original position in the socket groove to retain the pin. To
remove the socket, follow the installation procedures in
reverse.
OPERATION
The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc. The relation between fastening
torque and fastening time is shown in the figures.
3 4 5
Fastening time
5
1. Socket
2
2. O-ring
3. Pin
3
For 6905B
Rated voltage
90% of rated voltage
6 7 8
(S)