Working Safely - Festo 8034566 Notice D'utilisation


The MPS may only be used:
•
For its intended purpose
•
When its safety functions are in flawless condition

4.5 Working safely

General information
•
Trainees may only work with the circuits under the supervision of a trainer.
•
Electrical devices (e.g. power supply units, compressors and hydraulic power units) may only be
operated in training rooms which are equipped with residual current devices (RCDs).
•
Observe the specifications included in the technical data for the individual components, and in
particular all safety instructions!
•
Malfunctions which may impair safety must not be generated in the training environment, and must be
eliminated immediately.
•
Wear personal protective equipment (safety goggles, safety shoes) when working on circuits.
Mechanical safety
•
Switch off the power supply!
– Switch off the working as well as the control power before working on the circuit.
– Only reach into the setup when it's at a complete standstill.
– Observe possible overruning of the drives.
•
Mount all of the components securely onto the slotted profile plate.
•
Make sure that limit switches are not actuated from the front.
•
Risk of injury during troubleshooting!
Use a tool to actuate the limit switches, for example a screwdriver.
•
Set all components up so that activation of switches and disconnectors is not made difficult.
• Follow to the instructions regarding positioning of the components.
28
Malfunctions which may impair safety must be eliminated immediately!
© Festo Didactic 8034662