Everyday Maintenance; Operating Anomalies - Eurocave V101 Mode D'emploi

Gamme première
Masquer les pouces Voir aussi pour V101:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
8 - E
Your EuroCave wine cabinet is a tried and tested, easy-to-use appliance. The following few maintenance
operations will enable your cabinet to provide you with many years of faithful service.
- Each year, you should replace the active carbon filter located in the upper breather hole of your cabinet.
Manually remove the carbon filter (see diagram opposite). You can obtain a replacement carbon filter from
your usual retailer. The replacement part should have an original manufacturer's guarantee.
- Clean and dust the condenser (metal grid located the length of the rear wall of the cabinet) twice a year.
- When cleaning the back of the cabinet, and before moving it, make sure it has been disconnected from the
mains power supply and that there are no bottles left in the cabinet.
- Once a year completely clean the interior of your cabinet after emptying it and ensuring it disconnected
from the power supply (use water and a non abrasive cleaning product, then rinse carefully).
Checking the appliance regularly and, if you suspect that something is not functioning
correctly, notifying your retailer of this possible anomaly, is the best way to ensure that your
wine cabinet will provide you with long and faithful service.
9 - O
In the event of your cabinet not operating correctly, please contact your EuroCave wine cabinet retailer.
- If the compressor does not start even though the desired temperature is lower (more than 2°C (36°F) than room temperature, check the wall socket by
plugging in any type of electric appliance, and make sure that the display is correctly supplied with power (see button "U" on the control panel).
- If the compressor does not stop, place your hand on the condenser (metal grid located the length of the rear wall of your appliance). Contact your dealer
if the condenser is cold. If the condenser is hot, set the
your dealer.
- In the event that the temperature sensor is faulty, the symbol "EI" or "-EI" is displayed.
Where the critical temperature threshold is exceeded, for temperatures below 3°C (37°F), the display indicates "LOI". For temperatures above 22°C (71°F),
the display indicates "HII".
Use of a glass door can change your wine cabinet's performance in certain extreme
temperature conditions.
Any intervention on the refrigeration unit must be carried out by a qualified
refrigeration technician, who will check the circuit is waterproof before powering up. In
the same way, any intervention on the electrical circuit must be carried out by a qualified
electrician.
12
VERYDAY MAINTENANCE
PERATING ANOMALIES
hot
temperature as high as possible. If the compressor does not stop, unplug the cabinet and contact

Publicité

Table des Matières
loading

Table des Matières