Operation - Husqvarna HA110 Manuel D'utilisation

6. Now make a final adjustment to give yourself a
comfortable working position. Tighten the screw.
CAUTION: The loop handle and hand
guard must not be fitted behind the
arrow marked on the shaft.
7. Fit the clutch sleeve and tighten the two mounting
bolts.
To assemble the cutting head
It is important that the hedge trimmer is laid on a flat
surface when you fit the cutting head. Otherwise the
cutting head may not be fitted straight.
1. Fit the cutting head to the shaft.
To do a check before start
1. Examine the work area. Remove any objects that
could be thrown out.
2. Examine the cutting attachment. Do not use blades
that are damaged.
3. Examine that the product is in perfect work order.
Examine that all nuts and screws are tight.
4. Make sure the gear housing is lubricated correctly.
To lubricate the gear housing on page 10 for
See
instructions.
5. Examine that the cutting attachment stops when the
throttle/power trigger is released.
6. Only use the product for the purpose it was intended
for.
7. Make sure that the handle and safety features are in
good working order. Never use a product that lacks a
part or has been modified outside its specifications.
8
2. Tighten the lower screw first, then the upper screw.
To assemble the handle (HA850)
1. Install the handle with the 2 screws.

Operation

To operate the product
1. Work with a swinging action from the bottom
upwards when trimming sides.
2. Adjust the throttle/speed setting to suit the load.
3. When you use a gasoline operated product to cut a
hedge, make sure the engine face away from the
hedge.
CAUTION: Make sure the drive shaft
inside the shaft engages with the recess
in the cutting head.
820 - 002 -