Maintenance - Husqvarna HA110 Manuel D'utilisation

Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.
To perform maintenance on the
attachment
To do daily maintenance
A
1. Examine that the blades (A) do not move when the
throttle/power trigger is released or when the choke
is in the start position.
2. Examine that the hand guard (B) (HA110) is not
damaged. Replace the guard if necessary.
To perform weekly maintenance
A
1. Fill the gear housing (A) with grease. New products
are first filled with grease after approximately 20
hours of operation, and subsequently approximately
every 60 hours of operation.
2. Check that the screws that hold the blades together
(B) are correctly tightened.
To lubricate the gear housing
CAUTION: The gear housing must not be
filled completely with grease. The grease
10

Maintenance

B
B
expands as the product heats up during
operation. If the gear housing is completely
filled with grease it can damage the seals
and lead to leakage of grease.
There is a grease nipple and a plug for filling lubricant
on the gear housing.
1. Use a grease gun to fill with grease.
Note: New products are first filled with grease after
approximately 20 hours of operation, and
subsequently approximately every 60 hours of
operation. Use Husqvarna AB special grease, no.
503 98 96-01. The grease in the bevel gear does not
normally need to be changed except if repairs are
carried out.
To clean and lubricate the cutter
1. Clean any resin and plant residue from the blades
with a cleaning agent before and after the use of the
product.
2. Lubricate the blade bars with spray grease before
long periods of storage.
820 - 002 -