Télécharger Imprimer la page

ESTEBAN CMP-146 Notice D'utilisation page 15

Diffuseur brume de parfum

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
REPAIR
If the product is not working properly, check the following points:
Problems / Symptoms
The diffuser does not start up or
switches off during diffusion
No mist when the appliance is switched
on
Mist stops while the diffuser is in
THE
operation
d any
Insufficient mist
clean
you
nce.
riod,
ction
The light does not switch on
The touch-sensitive lights are not
working
The alarm clock is not working
Should the problems persist please contact your retailer.
The manufacturer is not responsible for damages caused by improper use of the diffuser.
CMP-146_NoticeDiffuseurBlackT_09-17_v1.indd 15
Causes
The appliance is not plugged in
Water level too low
Water level exceeds 100 ml
The end of part A is obstructed
Water level too low
Accumulation of water drops at the mist
vent of part A
The ceramic disk is dirty
An excess of Estéban refresher oils or
essential oils has been poured into the
container
Accumulation of water drops at the mist
vent of part A
The upper part A is not attached correctly
to the diffuser base C
Diffuser failure
Solutions
Make sure that the power adapter is
properly connected to the appliance and fully
plugged in to the wall socket
Fill the water container
Empty out excess water
Make sure that nothing is preventing the
release of the mist
Fill the water container
Switch off the diffuser, remove part A then
clean off the accumulated water drops
Clean the ceramic disk as described in the
"CLEANING" instructions
Empty the appliance and clean it
Switch off the diffuser, remove part A then
clean off the accumulated water drops
Adjust the upper part A on the diffuser
base C
Bring the diffuser back to the retailer within
the after-sales service support legal deadline
20/09/2017 16:19
15

Publicité

loading