ESTEBAN CMP-146 Notice D'utilisation page 11

STARTING THE DIFFUSER
stem
Read the below-mentioned instructions carefully before starting the diffuser.
light
1
2
A
K
CMP-146_NoticeDiffuseurBlackT_09-17_v1.indd 11
STAGE 1
• Plug the appliance into a (mains) socket. Only use the electricity supply intended for this
purpose. Check that the electric plug is in conformity with your country's electricity
installation. If not, add a universal adapter to the plug (see non-exhaustive list of
countries on page 9).
• In order to avoid any accident, make sure that the cable is not located in an area where
people walk.
• Time display and 4 adjustment lights (in red).

Setting the time:
Touch the TIMER light "G"  for 3-4 seconds to make your adjustments (a beep sounds,
the time display and all the lights blink simultaneously).
• Touch the CLOCK&ALARM light "E"
to adjust the minutes.
• Touch the TIMER light "G"  once again for 3-4 seconds to save the desired time.
The time is recorded without touching the lights after a few seconds.
STAGE 2
• Place the diffuser on a flat and stable surface away from the edge.
B
• Remove the upper part "A". Pour water at room temperature into the container, by using
the graduated glass "K".
Do not exceed the maximum level of 100ml. (Warning: the diffuser does not work
if the water level is too low or higher than 100ml).
to set the correct hour and touch LIGHT "F"
11
20/09/2017 16:19