ESTEBAN CMP-146 Notice D'utilisation page 13

4
STAGE 4
Touch the CLOCK&ALARM light "E"
display and all the lights blink simultaneously).
• Touch the CLOCK&ALARM light "E"
adjust the minutes.
• Touch the CLOCK&ALARM light "E"
The time is recorded without touching the lights after a few seconds.
Touch the CLOCK&ALARM light "E"
at the set time, the diffusion will begin accompanied by the luminous ambiance.
Touch the CLOCK&ALARM light "E"
at the set time, the diffusion and the luminous ambiance will begin accompanied by a ringing
tone that will last 1 minute and can be stopped by pressing the CLOCK&ALARM light "E"
Note: if the water level is too low, the mist diffuser cannot function properly and will switch into
the standby mode at the end of the alarm.
5
CMP-146_NoticeDiffuseurBlackT_09-17_v1.indd 13
Setting the alarm clock time:
"Timer programme" mode: (no ringing)
"Olfactory alarm clock" mode: (with ringing)
STAGE 5
Starting the luminous ambiance:
To accompany the diffusion, you can enjoy a moving display of different colours.
Touch LIGHT "F" to start the luminous ambiance. It will stop automatically when diffusion stops.
You can stop the luminous ambiance at any time by touching LIGHT "F" or the ON/OFF light
"D" (the luminous ambiance and the diffusion stop).
• Thanks to the automatic stop system, you can enjoy the perfumed atmosphere without
worrying about the diffuser.
• During the diffusion, the height of the mist may vary.
• When the appliance is operating, make sure not to put any obstacle above the
appliance that could hamper the release of the mist and not to remove the upper part
in order to avoid any splashing.
for 3-4 seconds to make your adjustments (the time
to set the correct hour and touch LIGHT "F"
once again for 3-4 seconds to save the desired time.
once; it will then shine green. The screen displays "01",
twice; it will then shine green. The screen displays "02";
to
.
13
20/09/2017 16:19