Baby Jogger City Select 2 Instructions D'assemblage page 15

WARNING: Always use the crotch strap
in combination with the shoulder straps
and waist belt.
25 Slide the harness pads up to access
plastic guide on strap.
26 Hold the plastic guide and pull strap to
tighten or loosen.
USING SAFETY HARNESS
27 Insert side strap buckle into harness
buckle on both sides.
28 Insert connected harness and side strap
buckles into the sides of the crotch
buckle.
29 Press button on crotch buckle to release.
PLACE THE SEAT ON THE FRAME
30 Align the seat mounting brackets with
the mounting brackets on the pushchair
frame. DO NOT use the seat in the top
position in lower brackets.
31 Insert the seat onto the brackets until it
clicks into place. Ensure that both sides
of the seat are securely fastened into the
frame before use.
NOTE: The seat may be installed either
forward-facing or rear-facing.
REMOVE THE SEAT
32 Press gray tabs on mounting brackets
and pull up.
WARNING: Always remove your child
from the seat before removing the seat
from the frame.
RECLINE THE SEAT
33 Squeeze the seat recline button located
at the top of the seat, behind the canopy.
34 Pull down to lower the seat and pull up
to raise the seat until it clicks into the
desired position.
WARNING: When making adjustments
to the stoller seat, make sure child's
head, arms, and legs are clear of moving
seat parts and pushchair frame.
HANDLE HEIGHT ADJUSTMENT
35 Squeeze the handle adjustment button
and slide the handle up or down to the
desired length.
ADJUSTABLE FOOTWELL
36 Adjust the angle: Press the adjustment
buttons on the footwell and move it up
or down until it clicks into the desired
position.
37 Adjust the length: press the bottom
buttons on the footwell and slide it in or
out until it clicks into place.
EXTENDABLE BASKET
38 To expand the basket, unzip the back of
the basket.
FOLDING
• Remove your child from the seat.
• The pushchair may be folded with or
without the seat attached.
• DO NOT fold product with rear facing
seat.
• For the most compact fold, either
remove seat or place seat
forward-facing with seat back inclined to
its most upright position.
39 Push down on fold actuator release
button on right hand side fold actuator
and pull up on the left and right fold
actuators, let pushchair handle rotate
down. Lift pushchair up by cross bar and
allow frame to fold closed. Make sure
the storage lock lever clicks into place.
BASKET REMOVAL
40 Unfasten the top snaps of the basket
around the middle support bar of the
frame. Then unfasten the bottom snaps
around the side support bars of the
frame.
41 Unhook the top front plastic attachment
loop from over the metal knob on
the front of the frame. Repeat for the
opposite side.
42 Remove basket by unhooking webbing
loop from the front wheel mount.
Reverse the steps to reattach the basket to
the frame.
REMOVING THE SEAT FABRIC
43 Unsnap the seat fabric from the seat
frame.
44 From the back of the seat, unfasten the
hook-and-loop and slide the strap
through the D-ring.
45 Press the footwell adjustment buttons
and pull out on the footwell to remove
the footwell bar from the seat frame.
46 Pull the seat fabric out of the channel in
the footwell bar.
47 Remove seat pad.
Reverse the steps to reattach the seat pad
to the seat frame.
LOWER BRACKET (use with carry cot or
infant car seat only)
48 Remove the mounting bracket plugs by
gently pulling on them.
15
EN