Baby Jogger City Select 2 Instructions D'assemblage page 14

FRAME
EN
1 Unpack the pushchair frame from the
box and set the wheels aside. Unlock
the pushchair by pulling the storage lock
.lever.
2 Lift the handlebar away from the lower
frame. The pushchair will click into place.
3 Place the pushchair in the upright
position.
WARNING: Ensure that all the locking
devices are engaged before use.
FRONT WHEEL
4 Installation
• Lay pushchair on its back so the
handlebar is resting on the floor.
• Attach the front wheel by sliding it into
the front wheel mount until it clicks.
Gently pull on the front wheel to make
sure it is properly attached.
5 Removal
• While pressing the front wheel release
button, gently slide the front wheel out
of the front wheel mount.
REAR WHEELS
6 Installation
• Align the rear wheel axle with the
wheel mount on the pushchair frame
and insert it into the wheel mount until
it clicks into place. You will hear a click.
• Gently pull on the rear wheel to make
sure it is properly attached.
7 Removal
• While pressing the wheel release
button, gently slide the rear wheel out
of the wheel mount.
BRAKE
8 To lock the brakes: push the brake lever
down to engage the brakes.
9 To release the brakes: lift the brake lever
up.
WARNING: Lock the brakes before
loading and unloading your child and
whenever the pushchair is not moving.
ASSEMBLING THE SEAT
10 Detach hook-and-loop strap from back
of seat.
11 Insert the footwell bar into the footwell
adjustment mounts on the lower portion
of the seat frame.
Press buttons on outside of foot bar and
slide the foot bar into the bracket until it
clicks into place.
12 From the back of the seat, fasten snaps
to seat frame.
13 From the back of the seat, wrap hook
-and-loop straps around seat frame, slide
the strap through the D-ring, and fasten
the hook-and-loop.
ATTACHING THE CANOPY
14 Attach the canopy's brackets to the
sides of the seat frame.
NOTE: canopy position can be adjusted
up and down the seat frame tube.
15 Attach the 3 fastening strips on the
canopy to the top of the seat.
16 Ensure that canopy mesh is covering
the seat back.
ATTACHING BELLY BAR (on certain
models)
17 Attach belly bar mount over RIGHT seat
mount by pushing seat mount button
in and sliding belly bar mount over seat
mount.
18 Push belly bar mount toward seat frame
until it clicks into frame and behind seat
mount button.
19 Attach belly bar over LEFT seat mount
by pushing seat mount button in and
sliding belly bar over seat mount until it
secures to frame.
20 Push belly bar toward seat frame until it
clicks into frame and behind seat mount
button.
21 To secure belly bar, rotate belly bar
down to connect to belly bar mount.
22 To open belly bar, (a) slide button
release on top of belly bar end, then
(b) press the button on bottom of belly
bar and (c) rotate upwards.
ADJUSTING SAFETY HARNESS
23 From the back of the seat, undo the
fastening strip and open the pocket to
locate the plastic square stopper. Turn
stopper and pass through the openings
in the PE board and seat fabric.
24 Reinsert stopper at seat opening closest
to child's shoulders. Pass back through
seat fabric and PE board. Tug on strap
to ensure stopper is locked. Repeat on
both sides.
WARNING: Avoid serious injury from
falling or sliding out. Always properly
adjust and fasten safety harness.
14