Télécharger Imprimer la page

Siemens EQ.700 classic TP7 Serie Manuel D'utilisation page 14

Masquer les pouces Voir aussi pour EQ.700 classic TP7 Serie:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33
en Before using for the first time
descaling. You can use the enclosed
test strip to check the water hardness
or ask your local water company.
Briefly dip the test strip in fresh tap
1.
water.
Allow the water to drip off the test
2.
strip.
Read the water hardness off the
3.
test strip after 1 minute.
The table shows allocation of the
levels to the different degrees of
water hardness:
Level German
degrees in
°dH
1
1-7
2
8-14
3
15-21
1
4
22-30
1
Factory setting
Note: If a water softening system is
installed in your house, you can se-
lect "Softening device".
Tip: You can change the settings at
any time.
→ "Basic settings", Page 20
6.3 Performing initial start-up
After connecting the appliance to the
power supply, configure the settings
for initial start-up. Initial start-up only
appears when switching on for the
first time.
Press
to switch the appliance
1.
on.
Follow the instructions on the dis-
2.
play.
a The display will guide you through
the programme.
Notes
¡ To set up Home Connect, refer to
the documents on Home Connect
supplied with the appliance.
14
Total hard-
ness in mmol/
l
0.18-1.25
1.42-2.49
2.67-3.74
3.92-5.34
¡ If "Demo mode" is selected, only
the display screens will work. You
can not dispense a beverage or
run a programme.
6.4 General information
Please bear this information in mind
so that you can get the best out of
your appliance.
Notes
¡ The appliance has been pro-
grammed at the factory with stand-
ard settings for optimum operation.
¡ The grinder has been factory-set
for optimum operation. If coffee is
only dispensed drop by drop or is
too thin and with too little crema,
you can adjust the grinding level
when the grinder is running.
→ "Adjusting the grinding level",
Page 16
¡ If you do not perform any actions
on the appliance for a certain
period, it will switch off automatic-
ally. You can change the duration
in the basic settings. → Page 20
¡ During operation water droplets
may form at the ventilation slits
and on the lid of the tablet com-
partment.
¡ For technical reasons steam can
escape from the appliance.

Publicité

loading