Cleaning Care - WMF 3 Mode D'emploi

Mixeur plongeant
Masquer les pouces Voir aussi pour 3:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• Stop using the appliance and/or connect it from the mains
• Do not immerse the drive unit in water.
• Do not use the appliance outdoors.
• No liability is accepted for damages resulting from misuse,
• The appliance is not designed for commercial use.
• Never reach into the blades when in use.
Start up
The immersion blender can be used to blend soft fruit and
cooked vegetables, or to prepare baby food or purees. Large
items should be roughly chopped beforehand.
Food Processing Tips
Food
Carrot
Cooked Potato
Beef
Icing
(egg white +
icing sugar)
Suggested to take rest for 2 minutes between cycles.
Please clean all parts as described in the 'cleaning and care'
section before allowing them to come into contact with food-
stuffs. Prepare the desired foodstuff and place in a container
which is sufficiently large, tall and stable, such as the measuring
cup provided.
10
plug immediately if:
• The appliance or mains cable is damaged
• There is any suspicion of a fault after dropping the
appliance or similar.
• In such cases, send the appliance to be repaired.
incorrect operation, improper repairs or the use of accessories
not designed for this appliance. Claims under warranty are
likewise excluded in such cases.
Recommended
Quantity (Max)
260 g
310 g
200 g
Egg White: 65 g,
Icing Sugar: 400g
Suggested
Times
10 sec
7 sec
15 sec
15 sec
Caution! The container provided is not heat resistant. Allow
boiled foodstuffs to cool somewhat before beginning.
Make sure that the appliance is disconnected from
the power supply.
Attach the blender or chopper bowl at the bottom of the drive
unit by turning the drive unit clock-wise against the blender/
chopper bowl until you hear an audible click from the blender/
chopper bowl, meaning that it is locked in place. The triangle
symbol on the drive unit should now be at the position of the
closed symbol of the blender/ chopper bowl. There should not
be any gap between the driver unit and the blender / chopper
bowl. The blender/ chopper bowl must be held firmly in the
drive unit and should not wobble or fall out.
Choose the desired speed setting using the two speed buttons
on the appliance. Hold the blender in the foodstuff.
Caution: spattering is likely when using the blender. To avoid
any spattering, the lower end with the blender blades should
always be entirely covered. For liquid foodstuffs, the appliance
should always be held at a slight angle for improved blending.
If using hot foodstuffs, be careful not to hold the appliance in
the steam to avoid any condensation forming on the drive unit.
If necessary, protect the drive unit and your hands from hot
steam with a small, clean kitchen towel. Wipe any condensation
off the housing immediately.
Now connect the mains plug to the socket. Hold the appliance
firmly in one hand and press one of the speed buttons. The mo-
tor will begin to operate. As soon as your foodstuff has reached
the desired consistency, and after a maximum of one minute,
release the speed button. Wait until the motor and the blades
have come to a stop, then remove the blender / chopper bowl
from the appliance.
Always remove the mains plug from the socket before placing
theappliance on a suitable surface.

Cleaning care

Disconnect the mains plug immediately after use.
Always clean the blender immediately after use to prevent
dried-on leftovers from damaging the bearing of the blender /
chopper bowl. For preliminary cleaning, let the blender run for a
short period time in a container with hot water. Let the chopper
bowl run for a short period time with hot water.
The blender/ chopper bowl is locked into the appliance during
11

Publicité

Table des Matières
loading

Table des Matières