Cleaning And Care - WMF Kult Pro Mode D'emploi

Cleaning and care

After use, switch the appliance off using the on/off switch and pull the mains plug out of the socket.
The drive unit should never be placed in water, only wiped down with a damp cloth. Never use abrasive
cleaning agents. Be sure to avoid injury on the sharp blades when cleaning the jug. Use the cleaning
programme for simple cleaning of the mixing container. Immediately after blending, fill the mixing
container with warm tap water (max. 1 litre), place the lid with the closing cap onto the mixing
container and start the cleaning programme. When the programme has ended, remove the container
and rinse with clean water.
Warning: The mixing container, blade unit and seals must not be placed in the dishwasher.
Note: The blade unit must not be removed for cleaning.
To avoid damage, clean the lid, closing cap and tamper with warm water.
For UK use only
▪ This product is supplied with a 13 A plug conforming to BS 1363 fitted to the mains lead. If the
plug is unsuitable for your socket outlets or needs to be replaced, please note the following. If the
plug is a non-rewireable one, cut it from the mains lead and immediately dispose of it. Never insert
it into a socket outlet as there is a very great risk of an electric shock.
▪ The replacement of the plug at the mains lead has to be done according to the following
instructions:
Important: The wires in this mains lead are coloured in accordance with the following code:
blue Neutral
brown Live
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
⋅ the wire which is coloured blue must be connected to the terminal which is marked with the
letter N or coloured black,
⋅ the wire which is coloured brown must be connected to the terminal which is marked with
the letter L or coloured red.
Do not connect any wire to the terminal which is marked
with the letter E or by the earth symbol , or coloured green or green and yellow.
▪ If a 13 A (BS 1363) plug is used it must be fitted with a 13 A fuse conforming to BS 1362 and be
ASTA approved. If any other type of plug is used, the appliance must be protected by a 10 A fuse
either in the plug or adapter or at the distribution board.
If in doubt - consult a qualified electrician.
▪ Never use the plug without closing the fuse cover.
18
The appliance complies with European directives 2014/35/EU, 2014/30/EU and
2009/125/EU.
Conformity with EN60335 Clause 11 was checked.
At the end of its life, this product may not be disposed of in normal household
waste, but must instead be taken to a collection point for recycling electrical and
electronic appliances.
The materials are recyclable in accordance with their labelling. Reuse, recycling
and other ways of reutilising old appliances make an important contribution to
protecting our environment.
Please ask your local authorities for information about the appropriate disposal
point.
End users are personally responsible for deleting any personal data that may be
stored on appliances they are disposing of.
19