Sony HT-RT5 Manuel D'instructions page 38

Calibrating the
Appropriate Speaker
Settings Automatically
(Auto Calibration)
D.C.A.C. DX (Digital Cinema Auto
Calibration DX) brings you the ideal sound
experience by automatically adjusting the
setting of the speakers' distance,
location, and acoustic.
Notes
• The system outputs a loud test sound when
[Auto Calibration] starts. You cannot turn
the volume down. Give consideration to
children and neighbors.
• Before [Auto Calibration], make sure that
– the Bar Speaker, subwoofer and surround
speakers are turned on
1
Press HOME.
The home menu appears on the TV
screen.
2
Press / to select
3
Press / to select [Audio Settings],
then press .
4
Press / to select [Auto
Calibration], then press
The speaker layout display appears.
5
Connect the calibration mic to the
A.CAL MIC (ECM-AC3) jack on the
rear of the Bar Speaker.
Set up the calibration mic at ear level
using a tripod, etc. (not supplied). The
calibration mic should aim the TV
screen. The front of each speaker
should face the calibration mic, and
there should be no obstruction
between the speakers and the
calibration mic.
6
Press / to select [OK], then press
.
To cancel, select [Cancel].
38
GB
7
8
9
[Setup].
.
Press .
[Auto Calibration] starts.
The system adjusts the speaker
settings automatically.
Be quiet during the measurement.
Notes
• Before measurement, make sure that
the speaker power is on, and confirm
the position of the wireless speakers.
Auto Calibration
• While [
do not operate the system.
Confirm the result of [Auto
Calibration].
The distance and level for each
speaker appear on the TV screen.
Note
• If measurement fails, follow the
message then retry [Auto Calibration].
Press / to select [OK] or [Cancel],
then press .
The measurement is OK.
Disconnect the calibration mic, then
select [OK]. The result is
implemented.
The measurement is not OK.
Follow the message, then select [OK]
to retry.
] is in progress,