Replacing Filter; Replacing Oven Lights; Service Call Check - Bertazzoni KO30 PRO X Manuel D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

REPLACING FILTER

CHARCOAL FILTER
Charcoal Filter, which was installed in your over the range
microwave, is used for nonvented, recirculated installation.
The filter should be changed every 6 to 12 months depending
on use.
1. Disconnect power to the oven at the circuit breaker panel
or by unplugging.
2. Remove the three louver mounting screws and push down
carefully on the tab at each end of the louver to disengage
it. (See illustration.)
3. Pull the louver away from the unit.
4. Change the charcoal filter.
5. Carefully push the louver back into place (engaging both
the bottom and top tabs) and replace the screws removed
in step 2.
charcoal filter
(white side faces front)
screw
Please check the following before calling for service:
Place one cup of water in a glass measuring cup in the oven and close the door securely.
Operate the oven for one minute at HIGH 100%.
Does the oven light come on?
Does the cooling fan work?
(Put your hand over the rear ventilating openings.)
Does the turntable rotate?
(It is normal for the turntable to turn in either direction.)
Is the water in the oven warm?
If "NO" is the answer to any of the above questions, please check electrical outlet, fuse and/or circuit breaker. If they are functioning
properly, CONTACT YOUR NEAREST BERTAZZONI AUTHORIZED SERVICER.
A OVER THE RANGE MICROWAVE should never be serviced by a "do-it-yourself" repair person.
NOTE: If time appearing in the display is counting down very rapidly, check Demonstration Mode on page 15 and cancel.
OTX_Use & Care.indd 17
top tab
louver
screw
screw
bottom tab

SERVICE CALL CHECK

YES _______
YES _______
YES _______
YES _______
17

REPLACING OVEN LIGHTS

LIGHT BULBS
1. To replace light bulbs, first disconnect power to the oven
at the circuit breaker panel or by unplugging.
2. To release cover, remove the screw on the light cover.
(See illustration.)
3. Replace light bulbs with equivalent watt bulb available
from your Bertazzoni Authorized Servicer or parts
distributor. Bulbs are also available at most hardware
stores or lighting centers. DO NOT USE A BULB LARGER
THAN 30 WATTS.
4. Close light cover and secure with screw removed in step
2.
CAUTION —
Light cover may become very hot. Do not touch
glass when light is on.
Light cover
Screw
NO _______
NO _______
NO _______
NO _______
Light bulbs
2/25/11 8:15 AM

Publicité

Table des Matières
loading

Table des Matières