Adjusting The Volume; Selecting A Zone And Channel - Kenwood TK-2180 Mode D'emploi

To enter the password without using the DTMF keypad:
1 Rotate the selector to select a digit.
2 Press the C> key to accept the entered digit and move
to the next digit.
• Press the A or # key to delete an incorrect character.
Press and hold the A or # key to delete all entered
characters.
3 Press the S key to confirm the password.
• If you enter an incorrect password, an error tone sounds
and the transceiver remains locked.
A
DJUSTING THE
Rotate the Power switch/ Volume control to adjust the volume.
Clockwise increases the volume and counter-clockwise
decreases it.
S Z
ELECTING A
Select the desired zone using the selector or the keys
programmed as Zone Up/ Zone Down.
Select the desired channel using the selector or the keys
programmed as CH/GID (Channel/ Group ID) Up/ CH/GID
(Channel/ Group ID) Down.
Names can be programmed for zones and channels with up to
12 characters each. However, to fit on the display, names will
be abbreviated. Your dealer can set the zone name to a length
of 0 to 12 digits. Channel names will shorten appropriately, to
fit in the 12-digit display.
For example, if the channel name is "–CHANNEL1–" and the
zone name is "KENWOOD", and your dealer sets the zone
name to 3-digits, the following display will appear:
V
OLUME
C
ONE AND HANNEL
17