Nstalling The Ap Over The Niversal Onnector; Installing The (Optional ) Speaker / Microphone Or Headset - Kenwood TK-2180 Mode D'emploi

I
NSTALLING THE
If you are not using an optional
speaker/ microphone or headset,
install the cap over the universal
connector using the supplied
4 x 6 mm screw. Ensure that the
cap fits tightly over the connector.
I
NSTALLING THE
1 Insert the guide of the
speaker/ microphone
connector into the
groove of the universal
connector.
2 Secure the connector in
place using the attached
screw.
Note: When not using
an optional speaker/
microphone or headset,
install the cap over the
universal connector.
C
AP OVER THE
(O ) S
PTIONAL
U C
NIVERSAL
/ M
PEAKER ICROPHONE OR
<
>
ONNECTOR
<
>
H
9
EADSET