Nstalling Emoving The (Optional Battery Pack; Installing / Removing The (Optional ) Battery Pack - Kenwood TK-2180 Mode D'emploi

I / R
NSTALLING
1 Match the guides of the battery
pack with the corresponding
grooves on the upper rear of
the transceiver, then firmly
press the battery pack to lock it
in place.
2 Lock the safety catch to
prevent accidentally pressing
the release latch and removing
the battery pack.
3 To remove the battery pack,
lift the safety catch, press the
release latch, then pull the
battery pack away from the
transceiver.
Note:
◆ To lift the battery pack safety catch, use a piece of hardened
plastic or metal, such as a screwdriver, that is no more than
6 mm wide and 1 mm thick. It is imperative that you place the
implement under only the lip of the safety catch so that you do
not damage the release latch.
◆ Before charging a battery pack that is attached to the
transceiver, ensure that the safety catch is firmly closed.
◆ While operating the transceiver using a Li-ion or Ni-MH battery
pack in areas with an ambient temperature of –10°C and lower,
operating time may be shortened.
EMOVING THE
(O ) B
PTIONAL
P
ATTERY ACK
7